i2c/ARM: davinci: Deep refactoring of I2C recovery
Alter the DaVinci GPIO recovery fetch to use descriptors
all the way down into the board files.
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Acked-by: Sekhar Nori <nsekhar@ti.com>
Tested-by: Sekhar Nori <nsekhar@ti.com>
Acked-by: Arnd Bergmann <arnd@arndb.de>
Signed-off-by: Wolfram Sang <wsa@the-dreams.de>
diff --git a/arch/arm/mach-davinci/board-dm644x-evm.c b/arch/arm/mach-davinci/board-dm644x-evm.c
index b07c9b1..85e6fb3 100644
--- a/arch/arm/mach-davinci/board-dm644x-evm.c
+++ b/arch/arm/mach-davinci/board-dm644x-evm.c
@@ -13,6 +13,7 @@
#include <linux/dma-mapping.h>
#include <linux/platform_device.h>
#include <linux/gpio.h>
+#include <linux/gpio/machine.h>
#include <linux/i2c.h>
#include <linux/platform_data/pcf857x.h>
#include <linux/platform_data/at24.h>
@@ -595,18 +596,28 @@ static struct i2c_board_info __initdata i2c_info[] = {
},
};
+static struct gpiod_lookup_table i2c_recovery_gpiod_table = {
+ .dev_id = "i2c_davinci",
+ .table = {
+ GPIO_LOOKUP("davinci_gpio", 44, "sda",
+ GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN),
+ GPIO_LOOKUP("davinci_gpio", 43, "scl",
+ GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN),
+ },
+};
+
/* The msp430 uses a slow bitbanged I2C implementation (ergo 20 KHz),
* which requires 100 usec of idle bus after i2c writes sent to it.
*/
static struct davinci_i2c_platform_data i2c_pdata = {
.bus_freq = 20 /* kHz */,
.bus_delay = 100 /* usec */,
- .sda_pin = 44,
- .scl_pin = 43,
+ .gpio_recovery = true,
};
static void __init evm_init_i2c(void)
{
+ gpiod_add_lookup_table(&i2c_recovery_gpiod_table);
davinci_init_i2c(&i2c_pdata);
i2c_add_driver(&dm6446evm_msp_driver);
i2c_register_board_info(1, i2c_info, ARRAY_SIZE(i2c_info));