Use kthread instead of kernel_thread
Lcs uses low-level kernel_thread implementation.
All drivers should use <linux/kthread.h> API instead.
Signed-off-by: Klaus-Dieter Wacker <kdwacker@de.ibm.com>
Signed-off-by: Ursula Braun <ursula.braun@de.ibm.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/s390/net/lcs.c b/drivers/s390/net/lcs.c
index 083f787..840dbf3 100644
--- a/drivers/s390/net/lcs.c
+++ b/drivers/s390/net/lcs.c
@@ -39,6 +39,7 @@
#include <linux/in.h>
#include <linux/igmp.h>
#include <linux/delay.h>
+#include <linux/kthread.h>
#include <net/arp.h>
#include <net/ip.h>
@@ -1259,7 +1260,6 @@
struct in_device *in4_dev;
card = (struct lcs_card *) data;
- daemonize("regipm");
if (!lcs_do_run_thread(card, LCS_SET_MC_THREAD))
return 0;
@@ -1753,11 +1753,10 @@
struct lcs_card *card = container_of(work, struct lcs_card, kernel_thread_starter);
LCS_DBF_TEXT(5, trace, "krnthrd");
if (lcs_do_start_thread(card, LCS_RECOVERY_THREAD))
- kernel_thread(lcs_recovery, (void *) card, SIGCHLD);
+ kthread_run(lcs_recovery, card, "lcs_recover");
#ifdef CONFIG_IP_MULTICAST
if (lcs_do_start_thread(card, LCS_SET_MC_THREAD))
- kernel_thread(lcs_register_mc_addresses,
- (void *) card, SIGCHLD);
+ kthread_run(lcs_register_mc_addresses, card, "regipm");
#endif
}
@@ -2269,7 +2268,6 @@
int rc;
card = (struct lcs_card *) ptr;
- daemonize("lcs_recover");
LCS_DBF_TEXT(4, trace, "recover1");
if (!lcs_do_run_thread(card, LCS_RECOVERY_THREAD))