e1000e: cleanup whitespace
Signed-off-by: Bruce Allan <bruce.w.allan@intel.com>
Tested-by: Aaron Brown <aaron.f.brown@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
diff --git a/drivers/net/ethernet/intel/e1000e/ethtool.c b/drivers/net/ethernet/intel/e1000e/ethtool.c
index 7c8ca65..59c22bf 100644
--- a/drivers/net/ethernet/intel/e1000e/ethtool.c
+++ b/drivers/net/ethernet/intel/e1000e/ethtool.c
@@ -244,7 +244,7 @@
mac->autoneg = 1;
adapter->hw.phy.autoneg_advertised = ADVERTISE_1000_FULL;
break;
- case SPEED_1000 + DUPLEX_HALF: /* not supported */
+ case SPEED_1000 + DUPLEX_HALF: /* not supported */
default:
goto err_inval;
}
@@ -416,7 +416,7 @@
static int e1000_get_regs_len(struct net_device __always_unused *netdev)
{
-#define E1000_REGS_LEN 32 /* overestimate */
+#define E1000_REGS_LEN 32 /* overestimate */
return E1000_REGS_LEN * sizeof(u32);
}
@@ -433,22 +433,22 @@
regs->version = (1 << 24) | (adapter->pdev->revision << 16) |
adapter->pdev->device;
- regs_buff[0] = er32(CTRL);
- regs_buff[1] = er32(STATUS);
+ regs_buff[0] = er32(CTRL);
+ regs_buff[1] = er32(STATUS);
- regs_buff[2] = er32(RCTL);
- regs_buff[3] = er32(RDLEN(0));
- regs_buff[4] = er32(RDH(0));
- regs_buff[5] = er32(RDT(0));
- regs_buff[6] = er32(RDTR);
+ regs_buff[2] = er32(RCTL);
+ regs_buff[3] = er32(RDLEN(0));
+ regs_buff[4] = er32(RDH(0));
+ regs_buff[5] = er32(RDT(0));
+ regs_buff[6] = er32(RDTR);
- regs_buff[7] = er32(TCTL);
- regs_buff[8] = er32(TDLEN(0));
- regs_buff[9] = er32(TDH(0));
+ regs_buff[7] = er32(TCTL);
+ regs_buff[8] = er32(TDLEN(0));
+ regs_buff[9] = er32(TDH(0));
regs_buff[10] = er32(TDT(0));
regs_buff[11] = er32(TIDV);
- regs_buff[12] = adapter->hw.phy.type; /* PHY type (IGP=1, M88=0) */
+ regs_buff[12] = adapter->hw.phy.type; /* PHY type (IGP=1, M88=0) */
/* ethtool doesn't use anything past this point, so all this
* code is likely legacy junk for apps that may or may not exist
@@ -1379,7 +1379,7 @@
if (hw->phy.media_type == e1000_media_type_copper &&
hw->phy.type == e1000_phy_m88) {
- ctrl_reg |= E1000_CTRL_ILOS; /* Invert Loss of Signal */
+ ctrl_reg |= E1000_CTRL_ILOS; /* Invert Loss of Signal */
} else {
/* Set the ILOS bit on the fiber Nic if half duplex link is
* detected.
@@ -1613,7 +1613,7 @@
ew32(TDT(0), k);
e1e_flush();
msleep(200);
- time = jiffies; /* set the start time for the receive */
+ time = jiffies; /* set the start time for the receive */
good_cnt = 0;
/* receive the sent packets */
do {
@@ -1636,11 +1636,11 @@
*/
} while ((good_cnt < 64) && !time_after(jiffies, time + 20));
if (good_cnt != 64) {
- ret_val = 13; /* ret_val is the same as mis-compare */
+ ret_val = 13; /* ret_val is the same as mis-compare */
break;
}
if (jiffies >= (time + 20)) {
- ret_val = 14; /* error code for time out error */
+ ret_val = 14; /* error code for time out error */
break;
}
}