net: dsa: bcm_sf2: Defer port enabling to calling port_enable
There is no need to configure the enabled ports once in bcm_sf2_sw_setup() and
then a second time around when dsa_switch_ops::port_enable is called, just do
it when port_enable is called which is better in terms of power consumption and
correctness.
Reviewed-by: Vivien Didelot <vivien.didelot@savoirfairelinux.com>
Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/dsa/bcm_sf2.c b/drivers/net/dsa/bcm_sf2.c
index d7b53d5..8acbd17 100644
--- a/drivers/net/dsa/bcm_sf2.c
+++ b/drivers/net/dsa/bcm_sf2.c
@@ -890,14 +890,11 @@ static int bcm_sf2_sw_setup(struct dsa_switch *ds)
struct bcm_sf2_priv *priv = bcm_sf2_to_priv(ds);
unsigned int port;
- /* Enable all valid ports and disable those unused */
+ /* Disable unused ports and configure IMP port */
for (port = 0; port < priv->hw_params.num_ports; port++) {
- /* IMP port receives special treatment */
- if ((1 << port) & ds->enabled_port_mask)
- bcm_sf2_port_setup(ds, port, NULL);
- else if (dsa_is_cpu_port(ds, port))
+ if (dsa_is_cpu_port(ds, port))
bcm_sf2_imp_setup(ds, port);
- else
+ else if (!((1 << port) & ds->enabled_port_mask))
bcm_sf2_port_disable(ds, port, NULL);
}