pinctrl: provide documentation pointer
The PIN_CONFIG_OUTPUT parameter is really tricky to understand
and needs an explicit pointer to the documentation.
Cc: Tomasz Figa <t.figa@samsung.com>
Cc: Kyungmin Park <kyungmin.park@samsung.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
diff --git a/include/linux/pinctrl/pinconf-generic.h b/include/linux/pinctrl/pinconf-generic.h
index fb90ef5..282309d 100644
--- a/include/linux/pinctrl/pinconf-generic.h
+++ b/include/linux/pinctrl/pinconf-generic.h
@@ -82,8 +82,10 @@
* operation, if several modes of operation are supported these can be
* passed in the argument on a custom form, else just use argument 1
* to indicate low power mode, argument 0 turns low power mode off.
- * @PIN_CONFIG_OUTPUT: this will configure the pin in output, use argument
- * 1 to indicate high level, argument 0 to indicate low level.
+ * @PIN_CONFIG_OUTPUT: this will configure the pin as an output. Use argument
+ * 1 to indicate high level, argument 0 to indicate low level. (Please
+ * see Documentation/pinctrl.txt, section "GPIO mode pitfalls" for a
+ * discussion around this parameter.)
* @PIN_CONFIG_END: this is the last enumerator for pin configurations, if
* you need to pass in custom configurations to the pin controller, use
* PIN_CONFIG_END+1 as the base offset.