libertas: Extend MESH_CONFIG command to access non-volatile configuration
This patch is based on a patch from Shailendra Govardhan and Brian Cavagnolo.
It extends the MESH_CONFIG command to configure non-volatile parameters on
libertas devices that support them (e.g. OLPC Active Antenna).
This patch only implements the driver/firmware interface.
See http://dev.laptop.org/ticket/6823 for minimal testing results and known
issues.
Signed-off-by: Javier Cardona <javier@cozybit.com>
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/libertas/main.c b/drivers/net/wireless/libertas/main.c
index a87feba..01299c8 100644
--- a/drivers/net/wireless/libertas/main.c
+++ b/drivers/net/wireless/libertas/main.c
@@ -344,14 +344,15 @@
{
struct lbs_private *priv = to_net_dev(dev)->priv;
int enable;
- int ret;
+ int ret, action = CMD_ACT_MESH_CONFIG_STOP;
sscanf(buf, "%x", &enable);
enable = !!enable;
if (enable == !!priv->mesh_dev)
return count;
-
- ret = lbs_mesh_config(priv, enable, priv->curbssparams.channel);
+ if (enable)
+ action = CMD_ACT_MESH_CONFIG_START;
+ ret = lbs_mesh_config(priv, action, priv->curbssparams.channel);
if (ret)
return ret;
@@ -1257,9 +1258,11 @@
useful */
priv->mesh_tlv = 0x100 + 291;
- if (lbs_mesh_config(priv, 1, priv->curbssparams.channel)) {
+ if (lbs_mesh_config(priv, CMD_ACT_MESH_CONFIG_START,
+ priv->curbssparams.channel)) {
priv->mesh_tlv = 0x100 + 37;
- if (lbs_mesh_config(priv, 1, priv->curbssparams.channel))
+ if (lbs_mesh_config(priv, CMD_ACT_MESH_CONFIG_START,
+ priv->curbssparams.channel))
priv->mesh_tlv = 0;
}
if (priv->mesh_tlv) {