iwlwifi: mvm: configure power management in D3
Configure power management in the D3 firmware by sending
the power table command to it when suspending; this uses
some values that are more suitable to a low power state.
Signed-off-by: Alexander Bondar <alexander.bondar@intel.com>
Reviewed-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
diff --git a/drivers/net/wireless/iwlwifi/mvm/d3.c b/drivers/net/wireless/iwlwifi/mvm/d3.c
index 63d788a..4d3c978 100644
--- a/drivers/net/wireless/iwlwifi/mvm/d3.c
+++ b/drivers/net/wireless/iwlwifi/mvm/d3.c
@@ -1007,6 +1007,10 @@
if (ret)
goto out;
+ ret = iwl_mvm_power_update_mode(mvm, vif);
+ if (ret)
+ goto out;
+
/* must be last -- this switches firmware state */
ret = iwl_mvm_send_cmd_pdu(mvm, D3_CONFIG_CMD, CMD_SYNC,
sizeof(d3_cfg_cmd), &d3_cfg_cmd);
diff --git a/drivers/net/wireless/iwlwifi/mvm/power.c b/drivers/net/wireless/iwlwifi/mvm/power.c
index 6c5dfc9..f5bdfb7 100644
--- a/drivers/net/wireless/iwlwifi/mvm/power.c
+++ b/drivers/net/wireless/iwlwifi/mvm/power.c
@@ -138,7 +138,8 @@
/* Check skip over DTIM conditions */
if (!radar_detect && (dtimper <= 10) &&
- (iwlmvm_mod_params.power_scheme == IWL_POWER_SCHEME_LP)) {
+ (iwlmvm_mod_params.power_scheme == IWL_POWER_SCHEME_LP ||
+ mvm->cur_ucode == IWL_UCODE_WOWLAN)) {
cmd->flags |= cpu_to_le16(POWER_FLAGS_SKIP_OVER_DTIM_MSK);
cmd->num_skip_dtim = cpu_to_le32(2);
}
@@ -150,8 +151,13 @@
keep_alive = DIV_ROUND_UP(keep_alive, MSEC_PER_SEC);
cmd->keep_alive_seconds = keep_alive;
- cmd->rx_data_timeout = cpu_to_le32(100 * USEC_PER_MSEC);
- cmd->tx_data_timeout = cpu_to_le32(100 * USEC_PER_MSEC);
+ if (mvm->cur_ucode != IWL_UCODE_WOWLAN) {
+ cmd->rx_data_timeout = cpu_to_le32(100 * USEC_PER_MSEC);
+ cmd->tx_data_timeout = cpu_to_le32(100 * USEC_PER_MSEC);
+ } else {
+ cmd->rx_data_timeout = cpu_to_le32(10 * USEC_PER_MSEC);
+ cmd->tx_data_timeout = cpu_to_le32(10 * USEC_PER_MSEC);
+ }
}
int iwl_mvm_power_update_mode(struct iwl_mvm *mvm, struct ieee80211_vif *vif)