ath10k: fix pmf for wmi-tlv on qca6174
New wmi-tlv firmware uses HTT 3.0 protocol which
uses TX_FRM command for management frames (instead
of a dedicated command). To support PMF it is
necessary to provide explicit tailroom.
Signed-off-by: Marek Kwaczynski <marek.kwaczynski@tieto.com>
Signed-off-by: Michal Kazior <michal.kazior@tieto.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>
diff --git a/drivers/net/wireless/ath/ath10k/htt_tx.c b/drivers/net/wireless/ath/ath10k/htt_tx.c
index 2a8667e..c1961e7 100644
--- a/drivers/net/wireless/ath/ath10k/htt_tx.c
+++ b/drivers/net/wireless/ath/ath10k/htt_tx.c
@@ -454,6 +454,12 @@
}
skb_cb->htt.txbuf_paddr = paddr;
+ if ((ieee80211_is_action(hdr->frame_control) ||
+ ieee80211_is_deauth(hdr->frame_control) ||
+ ieee80211_is_disassoc(hdr->frame_control)) &&
+ ieee80211_has_protected(hdr->frame_control))
+ skb_put(msdu, IEEE80211_CCMP_MIC_LEN);
+
skb_cb->paddr = dma_map_single(dev, msdu->data, msdu->len,
DMA_TO_DEVICE);
res = dma_mapping_error(dev, skb_cb->paddr);