drm/i915: Remove plane_config from struct intel_crtc, v2.
Nothing depends on this outside initial hw readout, so keep this
struct on the stack instead.
Changes since v1:
- Remove unrelated changes.
Signed-off-by: Maarten Lankhorst <maarten.lankhorst@linux.intel.com>
Reviewed-by: Daniel Stone <daniels@collabora.com>
Signed-off-by: Daniel Vetter <daniel.vetter@ffwll.ch>
diff --git a/drivers/gpu/drm/i915/intel_display.c b/drivers/gpu/drm/i915/intel_display.c
index d013a34..b0a3120 100644
--- a/drivers/gpu/drm/i915/intel_display.c
+++ b/drivers/gpu/drm/i915/intel_display.c
@@ -15202,6 +15202,8 @@
drm_modeset_unlock_all(dev);
for_each_intel_crtc(dev, crtc) {
+ struct intel_initial_plane_config plane_config = {};
+
if (!crtc->active)
continue;
@@ -15212,15 +15214,14 @@
* can even allow for smooth boot transitions if the BIOS
* fb is large enough for the active pipe configuration.
*/
- if (dev_priv->display.get_initial_plane_config) {
- dev_priv->display.get_initial_plane_config(crtc,
- &crtc->plane_config);
- /*
- * If the fb is shared between multiple heads, we'll
- * just get the first one.
- */
- intel_find_initial_plane_obj(crtc, &crtc->plane_config);
- }
+ dev_priv->display.get_initial_plane_config(crtc,
+ &plane_config);
+
+ /*
+ * If the fb is shared between multiple heads, we'll
+ * just get the first one.
+ */
+ intel_find_initial_plane_obj(crtc, &plane_config);
}
}