IB/mlx5: Implement UD QP offloads for IPoIB in the TX flow
In order to support LSO and CSUM in the TX flow the driver does the
following:
* LSO bit for the enum mlx5_ib_qp_flags was added, indicates QP that
supports LSO offloads.
* Enables the special offload when the QP is created, and enable the
special work request id (IB_WR_LSO) when comes.
* Calculates the size of the WQE according to the new WQE format that
support these offloads.
* Handles the new WQE format when arrived, sets the relevant
fields, and copies the needed data.
Signed-off-by: Erez Shitrit <erezsh@mellanox.com>
Signed-off-by: Eran Ben Elisha <eranbe@mellanox.com>
Reviewed-by: Leon Romanovsky <leonro@mellanox.com>
Signed-off-by: Doug Ledford <dledford@redhat.com>
diff --git a/drivers/infiniband/hw/mlx5/main.c b/drivers/infiniband/hw/mlx5/main.c
index 03c418c..76b0939 100644
--- a/drivers/infiniband/hw/mlx5/main.c
+++ b/drivers/infiniband/hw/mlx5/main.c
@@ -504,6 +504,11 @@
(MLX5_CAP_ETH(dev->mdev, csum_cap)))
props->device_cap_flags |= IB_DEVICE_RAW_IP_CSUM;
+ if (MLX5_CAP_GEN(mdev, ipoib_basic_offloads)) {
+ props->device_cap_flags |= IB_DEVICE_UD_IP_CSUM;
+ props->device_cap_flags |= IB_DEVICE_UD_TSO;
+ }
+
props->vendor_part_id = mdev->pdev->device;
props->hw_ver = mdev->pdev->revision;