arcnet: Use network block comment style
Conformity can be useful.
Signed-off-by: Joe Perches <joe@perches.com>
Signed-off-by: Michael Grzeschik <m.grzeschik@pengutronix.de>
diff --git a/drivers/net/arcnet/capmode.c b/drivers/net/arcnet/capmode.c
index 36648d3..8391324 100644
--- a/drivers/net/arcnet/capmode.c
+++ b/drivers/net/arcnet/capmode.c
@@ -66,11 +66,11 @@
pkt = (struct archdr *)skb_mac_header(skb);
skb_pull(skb, ARC_HDR_SIZE);
- /* up to sizeof(pkt->soft) has already been copied from the card */
- /* squeeze in an int for the cap encapsulation */
-
- /* use these variables to be sure we count in bytes, not in
- sizeof(struct archdr) */
+ /* up to sizeof(pkt->soft) has already been copied from the card
+ * squeeze in an int for the cap encapsulation
+ * use these variables to be sure we count in bytes, not in
+ * sizeof(struct archdr)
+ */
pktbuf = (char *)pkt;
pkthdrbuf = (char *)pkthdr;
memcpy(pktbuf, pkthdrbuf, ARC_HDR_SIZE + sizeof(pkt->soft.cap.proto));
@@ -90,8 +90,7 @@
netif_rx(skb);
}
-/*
- * Create the ARCnet hard/soft headers for cap mode.
+/* Create the ARCnet hard/soft headers for cap mode.
* There aren't any soft headers in cap mode - not even the protocol id.
*/
static int build_header(struct sk_buff *skb,
@@ -104,8 +103,8 @@
BUGMSG(D_PROTO, "Preparing header for cap packet %x.\n",
*((int *)&pkt->soft.cap.cookie[0]));
- /*
- * Set the source hardware address.
+
+ /* Set the source hardware address.
*
* This is pretty pointless for most purposes, but it can help in
* debugging. ARCnet does not allow us to change the source address in
@@ -116,9 +115,8 @@
/* see linux/net/ethernet/eth.c to see where I got the following */
if (dev->flags & (IFF_LOOPBACK | IFF_NOARP)) {
- /*
- * FIXME: fill in the last byte of the dest ipaddr here to better
- * comply with RFC1051 in "noarp" mode.
+ /* FIXME: fill in the last byte of the dest ipaddr here to
+ * better comply with RFC1051 in "noarp" mode.
*/
pkt->hard.dest = 0;
return hdr_size;
@@ -172,7 +170,8 @@
sizeof(pkt->soft.cap.proto));
/* Skip the extra integer we have written into it as a cookie
- but write the rest of the message: */
+ * but write the rest of the message:
+ */
lp->hw.copy_to_card(dev, bufnum, ofs + 1,
((unsigned char *)&pkt->soft.cap.mes), length - 1);