arcnet: Use network block comment style
Conformity can be useful.
Signed-off-by: Joe Perches <joe@perches.com>
Signed-off-by: Michael Grzeschik <m.grzeschik@pengutronix.de>
diff --git a/drivers/net/arcnet/com90io.c b/drivers/net/arcnet/com90io.c
index 3233346..6ec36f9 100644
--- a/drivers/net/arcnet/com90io.c
+++ b/drivers/net/arcnet/com90io.c
@@ -137,8 +137,7 @@
#endif
}
-/*
- * We cannot probe for an IO mapped card either, although we can check that
+/* We cannot probe for an IO mapped card either, although we can check that
* it's where we were told it was, and even autoirq
*/
static int __init com90io_probe(struct net_device *dev)
@@ -196,8 +195,7 @@
goto err_out;
}
if (!dev->irq) {
- /*
- * if we do this, we're sure to get an IRQ since the
+ /* if we do this, we're sure to get an IRQ since the
* card has just reset and the NORXflag is on until
* we tell it to start receiving.
*/
@@ -272,8 +270,7 @@
return 0;
}
-/*
- * Do a hardware reset on the card, and set up necessary registers.
+/* Do a hardware reset on the card, and set up necessary registers.
*
* This should be called as little as possible, because it disrupts the
* token on the network (causes a RECON) and requires a significant delay.