IB/ipath: On unrecoverable errors, force link down, LEDs off
If the chip is no longer usable, LEDs should be turned off so system
can be found easily in the cluster.
Also some minor reorganizing so both chips print hardware error
message at same point and only if there were unrecovered errors
Signed-off-by: Dave Olson <dave.olson@qlogic.com>
Signed-off-by: Bryan O'Sullivan <bryan.osullivan@qlogic.com>
Signed-off-by: Roland Dreier <rolandd@cisco.com>
diff --git a/drivers/infiniband/hw/ipath/ipath_iba6120.c b/drivers/infiniband/hw/ipath/ipath_iba6120.c
index aa2b519..1b9c308 100644
--- a/drivers/infiniband/hw/ipath/ipath_iba6120.c
+++ b/drivers/infiniband/hw/ipath/ipath_iba6120.c
@@ -43,6 +43,8 @@
#include "ipath_kernel.h"
#include "ipath_registers.h"
+static void ipath_setup_pe_setextled(struct ipath_devdata *, u64, u64);
+
/*
* This file contains all the chip-specific register information and
* access functions for the QLogic InfiniPath PCI-Express chip.
@@ -407,8 +409,14 @@
* if any set that we aren't ignoring only make the
* complaint once, in case it's stuck or recurring,
* and we get here multiple times
+ * Force link down, so switch knows, and
+ * LEDs are turned off
*/
if (dd->ipath_flags & IPATH_INITTED) {
+ ipath_set_linkstate(dd, IPATH_IB_LINKDOWN);
+ ipath_setup_pe_setextled(dd,
+ INFINIPATH_IBCS_L_STATE_DOWN,
+ INFINIPATH_IBCS_LT_STATE_DISABLED);
ipath_dev_err(dd, "Fatal Hardware Error (freeze "
"mode), no longer usable, SN %.16s\n",
dd->ipath_serial);
@@ -482,7 +490,8 @@
dd->ipath_hwerrmask);
}
- ipath_dev_err(dd, "%s hardware error\n", msg);
+ if (*msg)
+ ipath_dev_err(dd, "%s hardware error\n", msg);
if (isfatal && !ipath_diag_inuse && dd->ipath_freezemsg) {
/*
* for /sys status file ; if no trailing } is copied, we'll