spi: Don't break user-visible strings to multiple source lines in drivers
User-visible strings are more difficult to grep from sources if they are
separated to multiple source lines. This is worse than over 80 columns long
line code style violation.
Fix this by making those to single-line strings or by breaking them between
variables.
While at there, convert if (printk_ratelimit()) dev_warn() to use
dev_warn_ratelimited in spi-pxa2xx.c.
Signed-off-by: Jarkko Nikula <jarkko.nikula@linux.intel.com>
Signed-off-by: Mark Brown <broonie@linaro.org>
diff --git a/drivers/spi/spi-bfin5xx.c b/drivers/spi/spi-bfin5xx.c
index 18b892e..b70a2bd 100644
--- a/drivers/spi/spi-bfin5xx.c
+++ b/drivers/spi/spi-bfin5xx.c
@@ -913,8 +913,9 @@
drv_data->cur_transfer = list_entry(drv_data->cur_msg->transfers.next,
struct spi_transfer, transfer_list);
- dev_dbg(&drv_data->pdev->dev, "got a message to pump, "
- "state is set to: baud %d, flag 0x%x, ctl 0x%x\n",
+ dev_dbg(&drv_data->pdev->dev,
+ "got a message to pump, state is set to: baud "
+ "%d, flag 0x%x, ctl 0x%x\n",
drv_data->cur_chip->baud, drv_data->cur_chip->flag,
drv_data->cur_chip->ctl_reg);
@@ -1013,8 +1014,8 @@
* but let's assume (for now) they do.
*/
if (chip_info->ctl_reg & ~bfin_ctl_reg) {
- dev_err(&spi->dev, "do not set bits in ctl_reg "
- "that the SPI framework manages\n");
+ dev_err(&spi->dev,
+ "do not set bits in ctl_reg that the SPI framework manages\n");
goto error;
}
chip->enable_dma = chip_info->enable_dma != 0
@@ -1050,17 +1051,17 @@
chip->chip_select_num = spi->chip_select;
if (chip->chip_select_num < MAX_CTRL_CS) {
if (!(spi->mode & SPI_CPHA))
- dev_warn(&spi->dev, "Warning: SPI CPHA not set:"
- " Slave Select not under software control!\n"
- " See Documentation/blackfin/bfin-spi-notes.txt\n");
+ dev_warn(&spi->dev,
+ "Warning: SPI CPHA not set: Slave Select not under software control!\n"
+ "See Documentation/blackfin/bfin-spi-notes.txt\n");
chip->flag = (1 << spi->chip_select) << 8;
} else
chip->cs_gpio = chip->chip_select_num - MAX_CTRL_CS;
if (chip->enable_dma && chip->pio_interrupt) {
- dev_err(&spi->dev, "enable_dma is set, "
- "do not set pio_interrupt\n");
+ dev_err(&spi->dev,
+ "enable_dma is set, do not set pio_interrupt\n");
goto error;
}
/*