IB/ipath: Remove support for QLogic PCIe QLE devices
The ib_qib driver is taking over support for QLogic PCIe QLE devices,
so remove support for them from ib_ipath. The ib_ipath driver now
supports only the obsolete QLogic Hyper-Transport IB host channel
adapter (model QHT7140).
Signed-off-by: Ralph Campbell <ralph.campbell@qlogic.com>
Signed-off-by: Roland Dreier <rolandd@cisco.com>
diff --git a/drivers/infiniband/hw/ipath/ipath_driver.c b/drivers/infiniband/hw/ipath/ipath_driver.c
index 6302626..2133746 100644
--- a/drivers/infiniband/hw/ipath/ipath_driver.c
+++ b/drivers/infiniband/hw/ipath/ipath_driver.c
@@ -132,18 +132,13 @@
/* Only needed for registration, nothing else needs this info */
#define PCI_VENDOR_ID_PATHSCALE 0x1fc1
-#define PCI_VENDOR_ID_QLOGIC 0x1077
#define PCI_DEVICE_ID_INFINIPATH_HT 0xd
-#define PCI_DEVICE_ID_INFINIPATH_PE800 0x10
-#define PCI_DEVICE_ID_INFINIPATH_7220 0x7220
/* Number of seconds before our card status check... */
#define STATUS_TIMEOUT 60
static const struct pci_device_id ipath_pci_tbl[] = {
{ PCI_DEVICE(PCI_VENDOR_ID_PATHSCALE, PCI_DEVICE_ID_INFINIPATH_HT) },
- { PCI_DEVICE(PCI_VENDOR_ID_PATHSCALE, PCI_DEVICE_ID_INFINIPATH_PE800) },
- { PCI_DEVICE(PCI_VENDOR_ID_QLOGIC, PCI_DEVICE_ID_INFINIPATH_7220) },
{ 0, }
};
@@ -521,30 +516,9 @@
/* setup the chip-specific functions, as early as possible. */
switch (ent->device) {
case PCI_DEVICE_ID_INFINIPATH_HT:
-#ifdef CONFIG_HT_IRQ
ipath_init_iba6110_funcs(dd);
break;
-#else
- ipath_dev_err(dd, "QLogic HT device 0x%x cannot work if "
- "CONFIG_HT_IRQ is not enabled\n", ent->device);
- return -ENODEV;
-#endif
- case PCI_DEVICE_ID_INFINIPATH_PE800:
-#ifdef CONFIG_PCI_MSI
- ipath_init_iba6120_funcs(dd);
- break;
-#else
- ipath_dev_err(dd, "QLogic PCIE device 0x%x cannot work if "
- "CONFIG_PCI_MSI is not enabled\n", ent->device);
- return -ENODEV;
-#endif
- case PCI_DEVICE_ID_INFINIPATH_7220:
-#ifndef CONFIG_PCI_MSI
- ipath_dbg("CONFIG_PCI_MSI is not enabled, "
- "using INTx for unit %u\n", dd->ipath_unit);
-#endif
- ipath_init_iba7220_funcs(dd);
- break;
+
default:
ipath_dev_err(dd, "Found unknown QLogic deviceid 0x%x, "
"failing\n", ent->device);