spi/spi_mpc8xxx: fix potential memory corruption.
tx_dma/rx_dma are already set to a dummy buffer when no
tx/rx buffer and t->tx_dma/t->rx_dma does not contain a dma
address, but NULL.
This may lead to corruption of kernel memory. Fix this by
leaving tx_dma/rx_dma alone.
Do not INIT_TX_RX while controller is enabled, this is bad according
to the MPC8321 manual.
Signed-off-by: Joakim Tjernlund <Joakim.Tjernlund@transmode.se>
Acked-by: Anton Vorontsov <cbouatmailru@gmail.com>
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
diff --git a/drivers/spi/spi_mpc8xxx.c b/drivers/spi/spi_mpc8xxx.c
index 14d0523..0dfc482 100644
--- a/drivers/spi/spi_mpc8xxx.c
+++ b/drivers/spi/spi_mpc8xxx.c
@@ -241,7 +241,6 @@
/* Turn off SPI unit prior changing mode */
mpc8xxx_spi_write_reg(mode, cs->hw_mode & ~SPMODE_ENABLE);
- mpc8xxx_spi_write_reg(mode, cs->hw_mode);
/* When in CPM mode, we need to reinit tx and rx. */
if (mspi->flags & SPI_CPM_MODE) {
@@ -258,7 +257,7 @@
}
}
}
-
+ mpc8xxx_spi_write_reg(mode, cs->hw_mode);
local_irq_restore(flags);
}
@@ -438,7 +437,7 @@
dev_err(dev, "unable to map tx dma\n");
return -ENOMEM;
}
- } else {
+ } else if (t->tx_buf) {
mspi->tx_dma = t->tx_dma;
}
@@ -449,7 +448,7 @@
dev_err(dev, "unable to map rx dma\n");
goto err_rx_dma;
}
- } else {
+ } else if (t->rx_buf) {
mspi->rx_dma = t->rx_dma;
}