| #include "yupik-iot-idp.dtsi" |
| #include "qcx6490-cnss.dtsi" |
| |
| &soc { |
| }; |
| |
| &pcie0 { |
| status = "ok"; |
| }; |
| |
| &pcie0_msi { |
| status = "ok"; |
| }; |
| |
| &pcie1 { |
| status = "ok"; |
| qcom,boot-option = <0x0>; |
| qcom,ep-gpio = <&tlmm 19 0>; |
| pinctrl-0 = <&pcie1_perst_default |
| &pcie1_clkreq_default |
| &pcie1_wake_default |
| &pcie1_ep_default>; |
| pinctrl-1 = <&pcie1_perst_default |
| &pcie1_clkreq_sleep |
| &pcie1_wake_default |
| &pcie1_ep_default>; |
| }; |
| |
| &pcie1_msi { |
| status = "ok"; |
| }; |
| |
| &pm7325_gpios { |
| usb2_vbus_boost { |
| usb2_vbus_boost_default: usb2_vbus_boost_default { |
| pins = "gpio8"; |
| function = "normal"; |
| output-low; |
| power-source = <0>; /* 1.8V input supply */ |
| }; |
| }; |
| }; |
| |
| &soc { |
| usb2_vbus_boost_reg: usb2_vbus_boost_reg { |
| compatible = "regulator-fixed"; |
| regulator-name = "usb2_vbus_boost_vreg"; |
| startup-delay-us = <4000>; |
| enable-active-high; |
| gpios = <&pm7325_gpios 8 0>; |
| |
| pinctrl-names = "default"; |
| pinctrl-0 = <&usb2_vbus_boost_default>; |
| }; |
| }; |
| |
| &usb1 { |
| vbus_dwc3-supply = <&usb2_vbus_boost_reg>; |
| qcom,default-mode-none; |
| status = "ok"; |
| }; |
| |
| &usb2_phy1 { |
| status = "ok"; |
| }; |