MIPS: DB1200: PCMCIA card detection must not be auto-enabled.
Same issues as SD card detection: One of both is always triggering and the
handlers take care to shut it up and enable the other. To avoid messages
about "unbalanced interrupt enable/disable" they must not be automatically
enabled when initally requested.
This was not an issue with the db1200_defconfig due to fortunate timings;
on a build without network chip support the warnings appear.
Signed-off-by: Manuel Lauss <manuel.lauss@gmail.com>
To: Linux-MIPS <linux-mips@linux-mips.org>
Patchwork: http://patchwork.linux-mips.org/patch/1133/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
diff --git a/drivers/pcmcia/db1xxx_ss.c b/drivers/pcmcia/db1xxx_ss.c
index 2d48196..0f4cc3f 100644
--- a/drivers/pcmcia/db1xxx_ss.c
+++ b/drivers/pcmcia/db1xxx_ss.c
@@ -146,7 +146,6 @@
static int db1x_pcmcia_setup_irqs(struct db1x_pcmcia_sock *sock)
{
int ret;
- unsigned long flags;
if (sock->stschg_irq != -1) {
ret = request_irq(sock->stschg_irq, db1000_pcmcia_stschgirq,
@@ -162,30 +161,23 @@
* active one disabled.
*/
if (sock->board_type == BOARD_TYPE_DB1200) {
- local_irq_save(flags);
-
ret = request_irq(sock->insert_irq, db1200_pcmcia_cdirq,
IRQF_DISABLED, "pcmcia_insert", sock);
- if (ret) {
- local_irq_restore(flags);
+ if (ret)
goto out1;
- }
ret = request_irq(sock->eject_irq, db1200_pcmcia_cdirq,
IRQF_DISABLED, "pcmcia_eject", sock);
if (ret) {
free_irq(sock->insert_irq, sock);
- local_irq_restore(flags);
goto out1;
}
- /* disable the currently active one */
+ /* enable the currently silent one */
if (db1200_card_inserted(sock))
- disable_irq_nosync(sock->insert_irq);
+ enable_irq(sock->eject_irq);
else
- disable_irq_nosync(sock->eject_irq);
-
- local_irq_restore(flags);
+ enable_irq(sock->insert_irq);
} else {
/* all other (older) Db1x00 boards use a GPIO to show
* card detection status: use both-edge triggers.