typo fixes
Most of these fixes were already submitted for old kernel versions, and were
approved, but for some reason they never made it into the releases.
Because this is a consolidation of a couple old missed patches, it touches both
Kconfigs and documentation texts.
Signed-off-by: Matt LaPlante <kernel1@cyberdogtech.com>
Acked-by: Randy Dunlap <randy.dunlap@oracle.com>
Signed-off-by: Adrian Bunk <bunk@kernel.org>
diff --git a/drivers/video/Kconfig b/drivers/video/Kconfig
index b3bf4ec..fb9d8d0 100644
--- a/drivers/video/Kconfig
+++ b/drivers/video/Kconfig
@@ -661,7 +661,7 @@
help
This enables support for the Hecuba board. This driver was tested
with an E-Ink 800x600 display and x86 SBCs through a 16 bit GPIO
- interface (8 bit data, 4 bit control). If you anticpate using
+ interface (8 bit data, 4 bit control). If you anticipate using
this driver, say Y or M; otherwise say N. You must specify the
GPIO IO address to be used for setting control and data.
@@ -815,7 +815,7 @@
help
This is the framebuffer device for the Sun XVR-500 and similar
graphics cards based upon the 3DLABS Wildcat chipset. The driver
- only works on sparc64 systems where the system firwmare has
+ only works on sparc64 systems where the system firmware has
mostly initialized the card already. It is treated as a
completely dumb framebuffer device.
@@ -828,7 +828,7 @@
help
This is the framebuffer device for the Sun XVR-2500 and similar
graphics cards based upon the 3DLABS Wildcat chipset. The driver
- only works on sparc64 systems where the system firwmare has
+ only works on sparc64 systems where the system firmware has
mostly initialized the card already. It is treated as a
completely dumb framebuffer device.
diff --git a/drivers/video/console/Kconfig b/drivers/video/console/Kconfig
index a22ccf9..267422f 100644
--- a/drivers/video/console/Kconfig
+++ b/drivers/video/console/Kconfig
@@ -27,7 +27,7 @@
The scrollback buffer of the standard VGA console is located in
the VGA RAM. The size of this RAM is fixed and is quite small.
If you require a larger scrollback buffer, this can be placed in
- System RAM which is dynamically allocated during intialization.
+ System RAM which is dynamically allocated during initialization.
Placing the scrollback buffer in System RAM will slightly slow
down the console.
diff --git a/drivers/video/omap/Kconfig b/drivers/video/omap/Kconfig
index 7f4d25b..f4fcf11 100644
--- a/drivers/video/omap/Kconfig
+++ b/drivers/video/omap/Kconfig
@@ -8,7 +8,7 @@
Frame buffer driver for OMAP based boards.
config FB_OMAP_BOOTLOADER_INIT
- bool "Check bootloader initializaion"
+ bool "Check bootloader initialization"
depends on FB_OMAP
help
Say Y here if you want to enable checking if the bootloader has