libata-link: linkify config/EH related functions
Make the following functions deal with ata_link instead of ata_port.
* ata_set_mode()
* ata_eh_autopsy() and related functions
* ata_eh_report() and related functions
* suspend/resume related functions
* ata_eh_recover() and related functions
Signed-off-by: Tejun Heo <htejun@gmail.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/ata/pata_optidma.c b/drivers/ata/pata_optidma.c
index 39fcba8..09ef725 100644
--- a/drivers/ata/pata_optidma.c
+++ b/drivers/ata/pata_optidma.c
@@ -324,25 +324,26 @@
/**
* optidma_set_mode - mode setup
- * @ap: port to set up
+ * @link: link to set up
*
* Use the standard setup to tune the chipset and then finalise the
* configuration by writing the nibble of extra bits of data into
* the chip.
*/
-static int optidma_set_mode(struct ata_port *ap, struct ata_device **r_failed)
+static int optidma_set_mode(struct ata_link *link, struct ata_device **r_failed)
{
+ struct ata_port *ap = link->ap;
u8 r;
int nybble = 4 * ap->port_no;
struct pci_dev *pdev = to_pci_dev(ap->host->dev);
- int rc = ata_do_set_mode(ap, r_failed);
+ int rc = ata_do_set_mode(link, r_failed);
if (rc == 0) {
pci_read_config_byte(pdev, 0x43, &r);
r &= (0x0F << nybble);
- r |= (optidma_make_bits43(&ap->link.device[0]) +
- (optidma_make_bits43(&ap->link.device[0]) << 2)) << nybble;
+ r |= (optidma_make_bits43(&link->device[0]) +
+ (optidma_make_bits43(&link->device[0]) << 2)) << nybble;
pci_write_config_byte(pdev, 0x43, r);
}
return rc;