| /* |
| * pata_cs5536.c - CS5536 PATA for new ATA layer |
| * (C) 2007 Martin K. Petersen <mkp@mkp.net> |
| * |
| * This program is free software; you can redistribute it and/or modify |
| * it under the terms of the GNU General Public License version 2 as |
| * published by the Free Software Foundation. |
| * |
| * This program is distributed in the hope that it will be useful, |
| * but WITHOUT ANY WARRANTY; without even the implied warranty of |
| * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the |
| * GNU General Public License for more details. |
| * |
| * You should have received a copy of the GNU General Public License |
| * along with this program; if not, write to the Free Software |
| * Foundation, Inc., 59 Temple Place, Suite 330, Boston, MA 02111-1307 USA |
| * |
| * Documentation: |
| * Available from AMD web site. |
| * |
| * The IDE timing registers for the CS5536 live in the Geode Machine |
| * Specific Register file and not PCI config space. Most BIOSes |
| * virtualize the PCI registers so the chip looks like a standard IDE |
| * controller. Unfortunately not all implementations get this right. |
| * In particular some have problems with unaligned accesses to the |
| * virtualized PCI registers. This driver always does full dword |
| * writes to work around the issue. Also, in case of a bad BIOS this |
| * driver can be loaded with the "msr=1" parameter which forces using |
| * the Machine Specific Registers to configure the device. |
| */ |
| |
| #include <linux/kernel.h> |
| #include <linux/module.h> |
| #include <linux/pci.h> |
| #include <linux/init.h> |
| #include <linux/blkdev.h> |
| #include <linux/delay.h> |
| #include <linux/libata.h> |
| #include <scsi/scsi_host.h> |
| #include <asm/msr.h> |
| |
| #define DRV_NAME "pata_cs5536" |
| #define DRV_VERSION "0.0.7" |
| |
| enum { |
| CFG = 0, |
| DTC = 1, |
| CAST = 2, |
| ETC = 3, |
| |
| MSR_IDE_BASE = 0x51300000, |
| MSR_IDE_CFG = (MSR_IDE_BASE + 0x10), |
| MSR_IDE_DTC = (MSR_IDE_BASE + 0x12), |
| MSR_IDE_CAST = (MSR_IDE_BASE + 0x13), |
| MSR_IDE_ETC = (MSR_IDE_BASE + 0x14), |
| |
| PCI_IDE_CFG = 0x40, |
| PCI_IDE_DTC = 0x48, |
| PCI_IDE_CAST = 0x4c, |
| PCI_IDE_ETC = 0x50, |
| |
| IDE_CFG_CHANEN = 0x2, |
| IDE_CFG_CABLE = 0x10000, |
| |
| IDE_D0_SHIFT = 24, |
| IDE_D1_SHIFT = 16, |
| IDE_DRV_MASK = 0xff, |
| |
| IDE_CAST_D0_SHIFT = 6, |
| IDE_CAST_D1_SHIFT = 4, |
| IDE_CAST_DRV_MASK = 0x3, |
| IDE_CAST_CMD_MASK = 0xff, |
| IDE_CAST_CMD_SHIFT = 24, |
| |
| IDE_ETC_NODMA = 0x03, |
| }; |
| |
| static int use_msr; |
| |
| static const u32 msr_reg[4] = { |
| MSR_IDE_CFG, MSR_IDE_DTC, MSR_IDE_CAST, MSR_IDE_ETC, |
| }; |
| |
| static const u8 pci_reg[4] = { |
| PCI_IDE_CFG, PCI_IDE_DTC, PCI_IDE_CAST, PCI_IDE_ETC, |
| }; |
| |
| static inline int cs5536_read(struct pci_dev *pdev, int reg, u32 *val) |
| { |
| if (unlikely(use_msr)) { |
| u32 dummy; |
| |
| rdmsr(msr_reg[reg], *val, dummy); |
| return 0; |
| } |
| |
| return pci_read_config_dword(pdev, pci_reg[reg], val); |
| } |
| |
| static inline int cs5536_write(struct pci_dev *pdev, int reg, int val) |
| { |
| if (unlikely(use_msr)) { |
| wrmsr(msr_reg[reg], val, 0); |
| return 0; |
| } |
| |
| return pci_write_config_dword(pdev, pci_reg[reg], val); |
| } |
| |
| /** |
| * cs5536_cable_detect - detect cable type |
| * @ap: Port to detect on |
| * @deadline: deadline jiffies for the operation |
| * |
| * Perform cable detection for ATA66 capable cable. Return a libata |
| * cable type. |
| */ |
| |
| static int cs5536_cable_detect(struct ata_port *ap) |
| { |
| struct pci_dev *pdev = to_pci_dev(ap->host->dev); |
| u32 cfg; |
| |
| cs5536_read(pdev, CFG, &cfg); |
| |
| if (cfg & (IDE_CFG_CABLE << ap->port_no)) |
| return ATA_CBL_PATA80; |
| else |
| return ATA_CBL_PATA40; |
| } |
| |
| /** |
| * cs5536_set_piomode - PIO setup |
| * @ap: ATA interface |
| * @adev: device on the interface |
| */ |
| |
| static void cs5536_set_piomode(struct ata_port *ap, struct ata_device *adev) |
| { |
| static const u8 drv_timings[5] = { |
| 0x98, 0x55, 0x32, 0x21, 0x20, |
| }; |
| |
| static const u8 addr_timings[5] = { |
| 0x2, 0x1, 0x0, 0x0, 0x0, |
| }; |
| |
| static const u8 cmd_timings[5] = { |
| 0x99, 0x92, 0x90, 0x22, 0x20, |
| }; |
| |
| struct pci_dev *pdev = to_pci_dev(ap->host->dev); |
| struct ata_device *pair = ata_dev_pair(adev); |
| int mode = adev->pio_mode - XFER_PIO_0; |
| int cmdmode = mode; |
| int dshift = adev->devno ? IDE_D1_SHIFT : IDE_D0_SHIFT; |
| int cshift = adev->devno ? IDE_CAST_D1_SHIFT : IDE_CAST_D0_SHIFT; |
| u32 dtc, cast, etc; |
| |
| if (pair) |
| cmdmode = min(mode, pair->pio_mode - XFER_PIO_0); |
| |
| cs5536_read(pdev, DTC, &dtc); |
| cs5536_read(pdev, CAST, &cast); |
| cs5536_read(pdev, ETC, &etc); |
| |
| dtc &= ~(IDE_DRV_MASK << dshift); |
| dtc |= drv_timings[mode] << dshift; |
| |
| cast &= ~(IDE_CAST_DRV_MASK << cshift); |
| cast |= addr_timings[mode] << cshift; |
| |
| cast &= ~(IDE_CAST_CMD_MASK << IDE_CAST_CMD_SHIFT); |
| cast |= cmd_timings[cmdmode] << IDE_CAST_CMD_SHIFT; |
| |
| etc &= ~(IDE_DRV_MASK << dshift); |
| etc |= IDE_ETC_NODMA << dshift; |
| |
| cs5536_write(pdev, DTC, dtc); |
| cs5536_write(pdev, CAST, cast); |
| cs5536_write(pdev, ETC, etc); |
| } |
| |
| /** |
| * cs5536_set_dmamode - DMA timing setup |
| * @ap: ATA interface |
| * @adev: Device being configured |
| * |
| */ |
| |
| static void cs5536_set_dmamode(struct ata_port *ap, struct ata_device *adev) |
| { |
| static const u8 udma_timings[6] = { |
| 0xc2, 0xc1, 0xc0, 0xc4, 0xc5, 0xc6, |
| }; |
| |
| static const u8 mwdma_timings[3] = { |
| 0x67, 0x21, 0x20, |
| }; |
| |
| struct pci_dev *pdev = to_pci_dev(ap->host->dev); |
| u32 dtc, etc; |
| int mode = adev->dma_mode; |
| int dshift = adev->devno ? IDE_D1_SHIFT : IDE_D0_SHIFT; |
| |
| if (mode >= XFER_UDMA_0) { |
| cs5536_read(pdev, ETC, &etc); |
| |
| etc &= ~(IDE_DRV_MASK << dshift); |
| etc |= udma_timings[mode - XFER_UDMA_0] << dshift; |
| |
| cs5536_write(pdev, ETC, etc); |
| } else { /* MWDMA */ |
| cs5536_read(pdev, DTC, &dtc); |
| |
| dtc &= ~(IDE_DRV_MASK << dshift); |
| dtc |= mwdma_timings[mode - XFER_MW_DMA_0] << dshift; |
| |
| cs5536_write(pdev, DTC, dtc); |
| } |
| } |
| |
| static struct scsi_host_template cs5536_sht = { |
| ATA_BMDMA_SHT(DRV_NAME), |
| }; |
| |
| static struct ata_port_operations cs5536_port_ops = { |
| .inherits = &ata_bmdma_port_ops, |
| .cable_detect = cs5536_cable_detect, |
| .set_piomode = cs5536_set_piomode, |
| .set_dmamode = cs5536_set_dmamode, |
| }; |
| |
| /** |
| * cs5536_init_one |
| * @dev: PCI device |
| * @id: Entry in match table |
| * |
| */ |
| |
| static int cs5536_init_one(struct pci_dev *dev, const struct pci_device_id *id) |
| { |
| static const struct ata_port_info info = { |
| .sht = &cs5536_sht, |
| .flags = ATA_FLAG_SLAVE_POSS, |
| .pio_mask = 0x1f, |
| .mwdma_mask = 0x07, |
| .udma_mask = ATA_UDMA5, |
| .port_ops = &cs5536_port_ops, |
| }; |
| |
| const struct ata_port_info *ppi[] = { &info, &ata_dummy_port_info }; |
| u32 cfg; |
| |
| if (use_msr) |
| printk(KERN_ERR DRV_NAME ": Using MSR regs instead of PCI\n"); |
| |
| cs5536_read(dev, CFG, &cfg); |
| |
| if ((cfg & IDE_CFG_CHANEN) == 0) { |
| printk(KERN_ERR DRV_NAME ": disabled by BIOS\n"); |
| return -ENODEV; |
| } |
| |
| return ata_pci_init_one(dev, ppi); |
| } |
| |
| static const struct pci_device_id cs5536[] = { |
| { PCI_VDEVICE(AMD, PCI_DEVICE_ID_AMD_CS5536_IDE), }, |
| { }, |
| }; |
| |
| static struct pci_driver cs5536_pci_driver = { |
| .name = DRV_NAME, |
| .id_table = cs5536, |
| .probe = cs5536_init_one, |
| .remove = ata_pci_remove_one, |
| #ifdef CONFIG_PM |
| .suspend = ata_pci_device_suspend, |
| .resume = ata_pci_device_resume, |
| #endif |
| }; |
| |
| static int __init cs5536_init(void) |
| { |
| return pci_register_driver(&cs5536_pci_driver); |
| } |
| |
| static void __exit cs5536_exit(void) |
| { |
| pci_unregister_driver(&cs5536_pci_driver); |
| } |
| |
| MODULE_AUTHOR("Martin K. Petersen"); |
| MODULE_DESCRIPTION("low-level driver for the CS5536 IDE controller"); |
| MODULE_LICENSE("GPL"); |
| MODULE_DEVICE_TABLE(pci, cs5536); |
| MODULE_VERSION(DRV_VERSION); |
| module_param_named(msr, use_msr, int, 0644); |
| MODULE_PARM_DESC(msr, "Force using MSR to configure IDE function (Default: 0)"); |
| |
| module_init(cs5536_init); |
| module_exit(cs5536_exit); |