IB/ipath: Fix QP error completion queue entries
When switching to the QP error state, the completion queue entries
(error or flush) were not being generated correctly.
Signed-off-by: Bryan O'Sullivan <bryan.osullivan@qlogic.com>
Signed-off-by: Roland Dreier <rolandd@cisco.com>
diff --git a/drivers/infiniband/hw/ipath/ipath_qp.c b/drivers/infiniband/hw/ipath/ipath_qp.c
index f119f00..64ea807 100644
--- a/drivers/infiniband/hw/ipath/ipath_qp.c
+++ b/drivers/infiniband/hw/ipath/ipath_qp.c
@@ -361,7 +361,7 @@
* @err: the receive completion error to signal if a RWQE is active
*
* Flushes both send and receive work queues.
- * QP s_lock should be held and interrupts disabled.
+ * The QP s_lock should be held and interrupts disabled.
*/
void ipath_error_qp(struct ipath_qp *qp, enum ib_wc_status err)
@@ -393,6 +393,8 @@
wc.port_num = 0;
if (qp->r_wrid_valid) {
qp->r_wrid_valid = 0;
+ wc.wr_id = qp->r_wr_id;
+ wc.opcode = IB_WC_RECV;
wc.status = err;
ipath_cq_enter(to_icq(qp->ibqp.send_cq), &wc, 1);
}
@@ -972,7 +974,7 @@
* @wc: the WC responsible for putting the QP in this state
*
* Flushes the send work queue.
- * The QP s_lock should be held.
+ * The QP s_lock should be held and interrupts disabled.
*/
void ipath_sqerror_qp(struct ipath_qp *qp, struct ib_wc *wc)
@@ -998,12 +1000,12 @@
wc->status = IB_WC_WR_FLUSH_ERR;
while (qp->s_last != qp->s_head) {
+ wqe = get_swqe_ptr(qp, qp->s_last);
wc->wr_id = wqe->wr.wr_id;
wc->opcode = ib_ipath_wc_opcode[wqe->wr.opcode];
ipath_cq_enter(to_icq(qp->ibqp.send_cq), wc, 1);
if (++qp->s_last >= qp->s_size)
qp->s_last = 0;
- wqe = get_swqe_ptr(qp, qp->s_last);
}
qp->s_cur = qp->s_tail = qp->s_head;
qp->state = IB_QPS_SQE;