[SCSI] qla4xxx: set device state as per Link UP and LINK DOWN
Link Down -> Mark all devices missing
Previously, the driver took no action on a Link Down,
and waited for the I/O on a dead connection to timeout
in the firmware before marking the DDB missing.
Link Up -> Mark all devices online
F/W will do auto login to all the devices only once.
After that its the responsibility of the driver to
relogin to devices whenever there is :
* Any sort of connection failure or
* KATO expires indicating target has logged out or
* I/O times out etc.
Signed-off-by: Vikas Chaudhary <vikas.chaudhary@qlogic.com>
Signed-off-by: Karen Higgins <karen.higgins@qlogic.com>
Signed-off-by: Ravi Anand <ravi.anand@qlogic.com>
Reviewed-by: Mike Christie <michaelc@cs.wisc.edu>
Signed-off-by: James Bottomley <James.Bottomley@suse.de>
diff --git a/drivers/scsi/qla4xxx/ql4_init.c b/drivers/scsi/qla4xxx/ql4_init.c
index 36ec02c..7f6cc2e 100644
--- a/drivers/scsi/qla4xxx/ql4_init.c
+++ b/drivers/scsi/qla4xxx/ql4_init.c
@@ -1279,6 +1279,7 @@
int status = QLA_ERROR;
int8_t ip_address[IP_ADDR_LEN] = {0} ;
+ clear_bit(AF_ONLINE, &ha->flags);
ha->eeprom_cmd_data = 0;
qla4x00_pci_config(ha);
@@ -1456,10 +1457,15 @@
* the device came back.
*/
} else {
- /* Device went away, try to relogin. */
- /* Mark device missing */
- if (atomic_read(&ddb_entry->state) == DDB_STATE_ONLINE)
+ /* Device went away, mark device missing */
+ if (atomic_read(&ddb_entry->state) == DDB_STATE_ONLINE) {
+ DEBUG2(dev_info(&ha->pdev->dev, "%s mark missing "
+ "ddb_entry 0x%p sess 0x%p conn 0x%p\n",
+ __func__, ddb_entry,
+ ddb_entry->sess, ddb_entry->conn));
qla4xxx_mark_device_missing(ha, ddb_entry);
+ }
+
/*
* Relogin if device state changed to a not active state.
* However, do not relogin if this aen is a result of an IOCTL