ASoC: wm8994: Support external capacitors on MICBIAS2 with jack detection
When an external capacitor is connected to MICBIAS2 on devices with
jack detection (which is not required but may be done in some systems)
then the loading may mean that better performance is obtained when
the microphone bias is enabled normally rather than using the low power
mode. Provide platform data allowing systems to indicate if they require
this.
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
diff --git a/include/linux/mfd/wm8994/pdata.h b/include/linux/mfd/wm8994/pdata.h
index 3fb1f40..dc3e050 100644
--- a/include/linux/mfd/wm8994/pdata.h
+++ b/include/linux/mfd/wm8994/pdata.h
@@ -185,6 +185,9 @@
unsigned int jd_scthr:2;
unsigned int jd_thr:2;
+ /* Configure WM1811 jack detection for use with external capacitor */
+ unsigned int jd_ext_cap:1;
+
/* WM8958 microphone bias configuration */
int micbias[2];
diff --git a/sound/soc/codecs/wm8994.c b/sound/soc/codecs/wm8994.c
index 77085c1..0b1c271 100644
--- a/sound/soc/codecs/wm8994.c
+++ b/sound/soc/codecs/wm8994.c
@@ -3172,6 +3172,14 @@
wm1811_jackdet_set_mode(codec,
WM1811_JACKDET_MODE_JACK);
+
+ if (wm8994->pdata->jd_ext_cap) {
+ mutex_lock(&codec->mutex);
+ snd_soc_dapm_disable_pin(&codec->dapm,
+ "MICBIAS2");
+ snd_soc_dapm_sync(&codec->dapm);
+ mutex_unlock(&codec->mutex);
+ }
}
}
@@ -3227,6 +3235,15 @@
snd_soc_update_bits(codec, WM8958_MICBIAS2,
WM8958_MICB2_DISCH, 0);
+ /* If required for an external cap force MICBIAS on */
+ if (wm8994->pdata->jd_ext_cap) {
+ mutex_lock(&codec->mutex);
+ snd_soc_dapm_force_enable_pin(&codec->dapm,
+ "MICBIAS2");
+ snd_soc_dapm_sync(&codec->dapm);
+ mutex_unlock(&codec->mutex);
+ }
+
/*
* Start off measument of microphone impedence to find
* out what's actually there.
@@ -3241,6 +3258,13 @@
snd_soc_update_bits(codec, WM8958_MICBIAS2,
WM8958_MICB2_DISCH, WM8958_MICB2_DISCH);
+ if (wm8994->pdata->jd_ext_cap) {
+ mutex_lock(&codec->mutex);
+ snd_soc_dapm_disable_pin(&codec->dapm, "MICBIAS2");
+ snd_soc_dapm_sync(&codec->dapm);
+ mutex_unlock(&codec->mutex);
+ }
+
snd_soc_jack_report(wm8994->micdet[0].jack, 0,
SND_JACK_MECHANICAL | SND_JACK_HEADSET |
wm8994->btn_mask);