can: at91_can: clean up usage of AT91_MB_RX_FIRST and AT91_MB_RX_NUM
This patch cleans up the usage of two macros which specify the mailbox
usage. AT91_MB_RX_FIRST and AT91_MB_RX_NUM define the first and the
number of RX mailboxes. The current driver uses these variables in an
unclean way; assuming that AT91_MB_RX_FIRST is 0;
This patch cleans up the usage of these macros, no longer assuming
AT91_MB_RX_FIRST == 0.
Signed-off-by: Marc Kleine-Budde <mkl@pengutronix.de>
Acked-by: Wolfgang Grandegger <wg@grandegger.com>
diff --git a/drivers/net/can/at91_can.c b/drivers/net/can/at91_can.c
index 7ef83d0..892c3d8 100644
--- a/drivers/net/can/at91_can.c
+++ b/drivers/net/can/at91_can.c
@@ -2,7 +2,7 @@
* at91_can.c - CAN network driver for AT91 SoC CAN controller
*
* (C) 2007 by Hans J. Koch <hjk@hansjkoch.de>
- * (C) 2008, 2009, 2010 by Marc Kleine-Budde <kernel@pengutronix.de>
+ * (C) 2008, 2009, 2010, 2011 by Marc Kleine-Budde <kernel@pengutronix.de>
*
* This software may be distributed under the terms of the GNU General
* Public License ("GPL") version 2 as distributed in the 'COPYING'
@@ -55,7 +55,8 @@
#define AT91_MB_RX_MASK(i) ((1 << (i)) - 1)
#define AT91_MB_RX_SPLIT 8
#define AT91_MB_RX_LOW_LAST (AT91_MB_RX_SPLIT - 1)
-#define AT91_MB_RX_LOW_MASK (AT91_MB_RX_MASK(AT91_MB_RX_SPLIT))
+#define AT91_MB_RX_LOW_MASK (AT91_MB_RX_MASK(AT91_MB_RX_SPLIT) & \
+ ~AT91_MB_RX_MASK(AT91_MB_RX_FIRST))
#define AT91_MB_TX_NUM (1 << AT91_MB_TX_SHIFT)
#define AT91_MB_TX_FIRST (AT91_MB_RX_LAST + 1)
@@ -254,7 +255,8 @@
set_mb_mode_prio(priv, i, AT91_MB_MODE_TX, 0);
/* Reset tx and rx helper pointers */
- priv->tx_next = priv->tx_echo = priv->rx_next = 0;
+ priv->tx_next = priv->tx_echo = 0;
+ priv->rx_next = AT91_MB_RX_FIRST;
}
static int at91_set_bittiming(struct net_device *dev)
@@ -590,10 +592,10 @@
"order of incoming frames cannot be guaranteed\n");
again:
- for (mb = find_next_bit(addr, AT91_MB_RX_NUM, priv->rx_next);
- mb < AT91_MB_RX_NUM && quota > 0;
+ for (mb = find_next_bit(addr, AT91_MB_RX_LAST + 1, priv->rx_next);
+ mb < AT91_MB_RX_LAST + 1 && quota > 0;
reg_sr = at91_read(priv, AT91_SR),
- mb = find_next_bit(addr, AT91_MB_RX_NUM, ++priv->rx_next)) {
+ mb = find_next_bit(addr, AT91_MB_RX_LAST + 1, ++priv->rx_next)) {
at91_read_msg(dev, mb);
/* reactivate mailboxes */
@@ -610,8 +612,8 @@
/* upper group completed, look again in lower */
if (priv->rx_next > AT91_MB_RX_LOW_LAST &&
- quota > 0 && mb >= AT91_MB_RX_NUM) {
- priv->rx_next = 0;
+ quota > 0 && mb > AT91_MB_RX_LAST) {
+ priv->rx_next = AT91_MB_RX_FIRST;
goto again;
}