libertas: if_spi: add ability to call board specific setup/teardown methods
In certain cases it is required to perform board specific actions
before activating libertas G-SPI interface. These actions may include
power up of the chip, GPIOs setup, proper pin-strapping and SPI
controller config.
This patch adds ability to call board specific setup/teardown methods
Signed-off-by: Mike Rapoport <mike@compulab.co.il>
Acked-by: Andrey Yurovsky <andrey@cozybit.com>
Acked-by: Dan Williams <dcbw@redhat.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/libertas/if_spi.c b/drivers/net/wireless/libertas/if_spi.c
index 7c02ea3..07311e7 100644
--- a/drivers/net/wireless/libertas/if_spi.c
+++ b/drivers/net/wireless/libertas/if_spi.c
@@ -42,6 +42,7 @@
struct if_spi_card {
struct spi_device *spi;
struct lbs_private *priv;
+ struct libertas_spi_platform_data *pdata;
char helper_fw_name[FIRMWARE_NAME_MAX];
char main_fw_name[FIRMWARE_NAME_MAX];
@@ -1022,6 +1023,17 @@
lbs_deb_enter(LBS_DEB_SPI);
+ if (!pdata) {
+ err = -EINVAL;
+ goto out;
+ }
+
+ if (pdata->setup) {
+ err = pdata->setup(spi);
+ if (err)
+ goto out;
+ }
+
/* Allocate card structure to represent this specific device */
card = kzalloc(sizeof(struct if_spi_card), GFP_KERNEL);
if (!card) {
@@ -1029,6 +1041,7 @@
goto out;
}
spi_set_drvdata(spi, card);
+ card->pdata = pdata;
card->spi = spi;
card->gpio_cs = pdata->gpio_cs;
card->prev_xfer_time = jiffies;
@@ -1158,6 +1171,8 @@
if_spi_terminate_spi_thread(card);
lbs_remove_card(priv); /* will call free_netdev */
gpio_free(card->gpio_cs);
+ if (card->pdata->teardown)
+ card->pdata->teardown(spi);
free_if_spi_card(card);
lbs_deb_leave(LBS_DEB_SPI);
return 0;