| Synaptics touch controller |
| |
| Required properties: |
| |
| - compatible : should be "synaptics,rmi4" |
| - reg : i2c slave address of the device |
| - interrupt-parent : parent of interrupt |
| - interrupts : touch sample interrupt to indicate presense or release |
| of fingers on the panel. |
| - synaptics,irq-gpio : irq gpio |
| - synaptics,reset-gpio : reset gpio |
| |
| Optional property: |
| - vdd-supply : Analog power supply needed to power device |
| - synaptics,reg-en : specify to indicate regulator is needed |
| - vcc_i2c-supply : Power source required to pull up i2c bus |
| - synaptics,i2c-pull-up : specify to indicate pull up is needed |
| - synaptics,button-map : virtual key code mappings to be used |
| - synaptics,x-flip : modify orientation of the x axis |
| - synaptics,y-flip : modify orientation of the y axis |
| - synaptics,panel-x : panel x dimension |
| - synaptics,panel-y : panel y dimension |
| |
| Example: |
| i2c@f9927000 { /* BLSP1 QUP5 */ |
| cell-index = <5>; |
| compatible = "qcom,i2c-qup"; |
| #address-cells = <1>; |
| #size-cells = <0>; |
| reg-names = "qup_phys_addr"; |
| reg = <0xf9927000 0x1000>; |
| interrupt-names = "qup_err_intr"; |
| interrupts = <0 99 0>; |
| gpios = <&msmgpio 19 0>, /* SCL */ |
| <&msmgpio 18 0>; /* SDA */ |
| qcom,i2c-bus-freq = <100000>; |
| qcom,i2c-src-freq = <19200000>; |
| |
| synaptics@20 { |
| compatible = "synaptics,rmi4" |
| reg = <0x20>; |
| interrupt-parent = <&msmgpio>; |
| interrupts = <17 0x2>; |
| vdd-supply = <&pm8226_l19>; |
| vcc_i2c-supply = <&pm8226_lvs1>; |
| synaptics,reset-gpio = <&msmgpio 16 0x00>; |
| synaptics,irq-gpio = <&msmgpio 17 0x00>; |
| synaptics,button-map = [8B 66 9E]; |
| synaptics,i2c-pull-up; |
| synaptics,reg-en; |
| }; |
| }; |