[SCSI] sd: Fix handling of NO_SENSE check condition
The current handling of NO_SENSE check condition is the same as
RECOVERED_ERROR, and assumes that in both cases, the I/O was fully
transferred.
We have seen cases of arrays returning with NO_SENSE (no error), but
the I/O was not completely transferred, thus residual set. Thus,
rather than return good_bytes as the entire transfer, set good_bytes
to 0, so that the midlayer then applies the residual in calculating
the transfer, and for sd, will fail the I/O and fall into a retry
path.
Signed-off-by: Jamie Wellnitz <Jamie.Wellnitz@emulex.com>
Signed-off-by: James Bottomley <James.Bottomley@HansenPartnership.com>
diff --git a/drivers/scsi/sd.c b/drivers/scsi/sd.c
index 7c4d2e6..55e6ed4 100644
--- a/drivers/scsi/sd.c
+++ b/drivers/scsi/sd.c
@@ -1054,7 +1054,6 @@
good_bytes = sd_completed_bytes(SCpnt);
break;
case RECOVERED_ERROR:
- case NO_SENSE:
/* Inform the user, but make sure that it's not treated
* as a hard error.
*/
@@ -1063,6 +1062,15 @@
memset(SCpnt->sense_buffer, 0, SCSI_SENSE_BUFFERSIZE);
good_bytes = scsi_bufflen(SCpnt);
break;
+ case NO_SENSE:
+ /* This indicates a false check condition, so ignore it. An
+ * unknown amount of data was transferred so treat it as an
+ * error.
+ */
+ scsi_print_sense("sd", SCpnt);
+ SCpnt->result = 0;
+ memset(SCpnt->sense_buffer, 0, SCSI_SENSE_BUFFERSIZE);
+ break;
case ABORTED_COMMAND:
if (sshdr.asc == 0x10) { /* DIF: Disk detected corruption */
scsi_print_result(SCpnt);