IB/ipath: Fix IB compliance problems with link state vs physical state
Subnet manager SetPortinfo messages distingush between changing the link
state (DOWN, ARM, ACTIVE) and the link physical state (POLL, SLEEP,
DISABLED). These are somewhat independent commands and affect when link
width and speed changes take effect. Without this patch, a link DOWN
physical state NOP command was causing the link width and speed settings
to take effect which should only happen when the link physical state is
goes down (either by a SMP or some link physical error like link errors
exceeding the threshold).
Signed-off-by: Ralph Campbell <ralph.campbell@qlogic.com>
Signed-off-by: Roland Dreier <rolandd@cisco.com>
diff --git a/drivers/infiniband/hw/ipath/ipath_kernel.h b/drivers/infiniband/hw/ipath/ipath_kernel.h
index 4cc0f95..ecf3f7f 100644
--- a/drivers/infiniband/hw/ipath/ipath_kernel.h
+++ b/drivers/infiniband/hw/ipath/ipath_kernel.h
@@ -767,6 +767,7 @@
int ipath_setrcvhdrsize(struct ipath_devdata *, unsigned);
int ipath_reset_device(int);
void ipath_get_faststats(unsigned long);
+int ipath_wait_linkstate(struct ipath_devdata *, u32, int);
int ipath_set_linkstate(struct ipath_devdata *, u8);
int ipath_set_mtu(struct ipath_devdata *, u16);
int ipath_set_lid(struct ipath_devdata *, u32, u8);