iwlwifi: unify SW rf-kill flow
This patch unifies SW rf-kill flow between 4965 and 5000. It enables SW
RF-kill for 5000. This patch also solves a bug in iwl4965_mac_config:
bad mutex locking balance.
Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
Signed-off-by: Tomas Winkler <tomas.winkler@intel.com>
Signed-off-by: Zhu Yi <yi.zhu@intel.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/iwlwifi/iwl4965-base.c b/drivers/net/wireless/iwlwifi/iwl4965-base.c
index a9da17c..f591168 100644
--- a/drivers/net/wireless/iwlwifi/iwl4965-base.c
+++ b/drivers/net/wireless/iwlwifi/iwl4965-base.c
@@ -379,28 +379,6 @@
sizeof(struct iwl4965_bt_cmd), &bt_cmd);
}
-/*
- * CARD_STATE_CMD
- *
- * Use: Sets the device's internal card state to enable, disable, or halt
- *
- * When in the 'enable' state the card operates as normal.
- * When in the 'disable' state, the card enters into a low power mode.
- * When in the 'halt' state, the card is shut down and must be fully
- * restarted to come back on.
- */
-static int iwl4965_send_card_state(struct iwl_priv *priv, u32 flags, u8 meta_flag)
-{
- struct iwl_host_cmd cmd = {
- .id = REPLY_CARD_STATE_CMD,
- .len = sizeof(u32),
- .data = &flags,
- .meta.flags = meta_flag,
- };
-
- return iwl_send_cmd(priv, &cmd);
-}
-
static void iwl_clear_free_frames(struct iwl_priv *priv)
{
struct list_head *element;
@@ -916,65 +894,6 @@
(IWL_OFDM_BASIC_RATES_MASK >> IWL_FIRST_OFDM_RATE) & 0xFF;
}
-int iwl4965_radio_kill_sw(struct iwl_priv *priv, int disable_radio)
-{
- unsigned long flags;
-
- if (!!disable_radio == test_bit(STATUS_RF_KILL_SW, &priv->status))
- return 0;
-
- IWL_DEBUG_RF_KILL("Manual SW RF KILL set to: RADIO %s\n",
- disable_radio ? "OFF" : "ON");
-
- if (disable_radio) {
- iwl_scan_cancel(priv);
- /* FIXME: This is a workaround for AP */
- if (priv->iw_mode != IEEE80211_IF_TYPE_AP) {
- spin_lock_irqsave(&priv->lock, flags);
- iwl_write32(priv, CSR_UCODE_DRV_GP1_SET,
- CSR_UCODE_SW_BIT_RFKILL);
- spin_unlock_irqrestore(&priv->lock, flags);
- /* call the host command only if no hw rf-kill set */
- if (!test_bit(STATUS_RF_KILL_HW, &priv->status) &&
- iwl_is_ready(priv))
- iwl4965_send_card_state(priv,
- CARD_STATE_CMD_DISABLE,
- 0);
- set_bit(STATUS_RF_KILL_SW, &priv->status);
-
- /* make sure mac80211 stop sending Tx frame */
- if (priv->mac80211_registered)
- ieee80211_stop_queues(priv->hw);
- }
- return 0;
- }
-
- spin_lock_irqsave(&priv->lock, flags);
- iwl_write32(priv, CSR_UCODE_DRV_GP1_CLR, CSR_UCODE_SW_BIT_RFKILL);
-
- clear_bit(STATUS_RF_KILL_SW, &priv->status);
- spin_unlock_irqrestore(&priv->lock, flags);
-
- /* wake up ucode */
- msleep(10);
-
- spin_lock_irqsave(&priv->lock, flags);
- iwl_read32(priv, CSR_UCODE_DRV_GP1);
- if (!iwl_grab_nic_access(priv))
- iwl_release_nic_access(priv);
- spin_unlock_irqrestore(&priv->lock, flags);
-
- if (test_bit(STATUS_RF_KILL_HW, &priv->status)) {
- IWL_DEBUG_RF_KILL("Can not turn radio back on - "
- "disabled by HW switch\n");
- return 0;
- }
-
- if (priv->is_open)
- queue_work(priv->workqueue, &priv->restart);
- return 1;
-}
-
#define IWL_PACKET_RETRY_TIME HZ
int iwl4965_is_duplicate_packet(struct iwl_priv *priv, struct ieee80211_hdr *header)
@@ -2982,13 +2901,14 @@
priv->add_radiotap = !!(conf->flags & IEEE80211_CONF_RADIOTAP);
-
- if (priv->cfg->ops->lib->radio_kill_sw &&
- priv->cfg->ops->lib->radio_kill_sw(priv, !conf->radio_enabled)) {
+ if (conf->radio_enabled && iwl_radio_kill_sw_enable_radio(priv)) {
IWL_DEBUG_MAC80211("leave - RF-KILL - waiting for uCode\n");
- mutex_unlock(&priv->mutex);
+ goto out;
}
+ if (!conf->radio_enabled)
+ iwl_radio_kill_sw_disable_radio(priv);
+
if (!iwl_is_ready(priv)) {
IWL_DEBUG_MAC80211("leave - not ready\n");
ret = -EIO;