arm/dt: msm8610: Enable regulator devices
Switch out the stub regulator devices to actual qpnp-regulator
devices so that consumer requests actually control hardware state.
Since RPM control is not yet available to control system level
constraints, configure always-on regulators such that they cannot be
disabled and so that they are always in high power mode (HPM). This set
of regulators consists of LDO 2, LDO 3, LDO 6, and all four SMPS
regulators.
Finally, bump up the max voltage on the S2 buck regulator since
the acpuclock consumer can scale from 1.05 to 1.15 volts.
Change-Id: Ibb8e650404399f5fabd6ed9900320b9c012944ad
Signed-off-by: Xiaozhe Shi <xiaozhes@codeaurora.org>
2 files changed