RTC: Convert rtc drivers to use the alarm_irq_enable method
Some rtc drivers use the ioctl method instead of the alarm_irq_enable
method for enabling alarm interupts. With the new virtualized RTC
rework, its important for drivers to use the alarm_irq_enable instead.
This patch converts the drivers that use the AIE ioctl method to
use the alarm_irq_enable method. Other ioctl cmds are left untouched.
I have not been able to test or even compile most of these drivers.
Any help to make sure this change is correct would be appreciated!
CC: Alessandro Zummo <a.zummo@towertech.it>
CC: Thomas Gleixner <tglx@linutronix.de>
CC: Marcelo Roberto Jimenez <mroberto@cpti.cetuc.puc-rio.br>
Reported-by: Marcelo Roberto Jimenez <mroberto@cpti.cetuc.puc-rio.br>
Tested-by: Marcelo Roberto Jimenez <mroberto@cpti.cetuc.puc-rio.br>
Signed-off-by: John Stultz <john.stultz@linaro.org>
diff --git a/drivers/rtc/rtc-sh.c b/drivers/rtc/rtc-sh.c
index 06e41ed..93314a9 100644
--- a/drivers/rtc/rtc-sh.c
+++ b/drivers/rtc/rtc-sh.c
@@ -350,10 +350,6 @@
unsigned int ret = 0;
switch (cmd) {
- case RTC_AIE_OFF:
- case RTC_AIE_ON:
- sh_rtc_setaie(dev, cmd == RTC_AIE_ON);
- break;
case RTC_UIE_OFF:
rtc->periodic_freq &= ~PF_OXS;
sh_rtc_setcie(dev, 0);
@@ -369,6 +365,12 @@
return ret;
}
+static int sh_rtc_alarm_irq_enable(struct device *dev, unsigned int enabled)
+{
+ sh_rtc_setaie(dev, enabled);
+ return 0;
+}
+
static int sh_rtc_read_time(struct device *dev, struct rtc_time *tm)
{
struct platform_device *pdev = to_platform_device(dev);
@@ -604,6 +606,7 @@
.irq_set_state = sh_rtc_irq_set_state,
.irq_set_freq = sh_rtc_irq_set_freq,
.proc = sh_rtc_proc,
+ .alarm_irq_enable = sh_rtc_alarm_irq_enable,
};
static int __init sh_rtc_probe(struct platform_device *pdev)