[ARM] locomo: fix SPI register offset
The locomo spi registers are all defined in locomo.h as offsets
from the first spi register LOCOMO_SPI (0x60), which is itself
an offset from the locomo base address. To correctly access
these registers LOCOMO_SPI must always be included in the
address calculation.
There are two places in locomo.c where this is not done. The
first one, in locomo_suspend, actually results in a write to
LOCOMO_ST instead of LOCOMO_SPICT. The second is in __locomo_probe
and results in a write to LOCOMO_MCSX2 instead of LOCOMO_SPIIE.
Fix these by including LOCOMO_SPI in the calculation.
Signed-off-by: H Hartley Sweeten <hsweeten@visionengravers.com>
Signed-off-by: Eric Miao <eric.y.miao@gmail.com>
diff --git a/arch/arm/common/locomo.c b/arch/arm/common/locomo.c
index 90ae00b..4f9ccf6 100644
--- a/arch/arm/common/locomo.c
+++ b/arch/arm/common/locomo.c
@@ -290,7 +290,7 @@
save->LCM_GPO = locomo_readl(lchip->base + LOCOMO_GPO); /* GPIO */
locomo_writel(0x00, lchip->base + LOCOMO_GPO);
save->LCM_SPICT = locomo_readl(lchip->base + LOCOMO_SPI + LOCOMO_SPICT); /* SPI */
- locomo_writel(0x40, lchip->base + LOCOMO_SPICT);
+ locomo_writel(0x40, lchip->base + LOCOMO_SPI + LOCOMO_SPICT);
save->LCM_GPE = locomo_readl(lchip->base + LOCOMO_GPE); /* GPIO */
locomo_writel(0x00, lchip->base + LOCOMO_GPE);
save->LCM_ASD = locomo_readl(lchip->base + LOCOMO_ASD); /* ADSTART */
@@ -418,7 +418,7 @@
/* Longtime timer */
locomo_writel(0, lchip->base + LOCOMO_LTINT);
/* SPI */
- locomo_writel(0, lchip->base + LOCOMO_SPIIE);
+ locomo_writel(0, lchip->base + LOCOMO_SPI + LOCOMO_SPIIE);
locomo_writel(6 + 8 + 320 + 30 - 10, lchip->base + LOCOMO_ASD);
r = locomo_readl(lchip->base + LOCOMO_ASD);