Merge master.kernel.org:/home/rmk/linux-2.6-arm
* master.kernel.org:/home/rmk/linux-2.6-arm:
[ARM] 3543/1: [Fwd: PXA270 bootparams address not set]
[ARM] Trivial typo fixes
diff --git a/arch/arm/Kconfig.debug b/arch/arm/Kconfig.debug
index 5d3acff..d22f38b 100644
--- a/arch/arm/Kconfig.debug
+++ b/arch/arm/Kconfig.debug
@@ -101,7 +101,7 @@
help
Choice for UART for kernel low-level using S3C2410 UARTS,
should be between zero and two. The port must have been
- initalised by the boot-loader before use.
+ initialised by the boot-loader before use.
The uncompressor code port configuration is now handled
by CONFIG_S3C2410_LOWLEVEL_UART_PORT.
diff --git a/arch/arm/mach-ixp4xx/Kconfig b/arch/arm/mach-ixp4xx/Kconfig
index 2a39f9e..3b23f43 100644
--- a/arch/arm/mach-ixp4xx/Kconfig
+++ b/arch/arm/mach-ixp4xx/Kconfig
@@ -141,7 +141,7 @@
2) If > 64MB of memory space is required, the IXP4xx can be
configured to use indirect registers to access PCI This allows
for up to 128MB (0x48000000 to 0x4fffffff) of memory on the bus.
- The disadvantadge of this is that every PCI access requires
+ The disadvantage of this is that every PCI access requires
three local register accesses plus a spinlock, but in some
cases the performance hit is acceptable. In addition, you cannot
mmap() PCI devices in this case due to the indirect nature
diff --git a/arch/arm/mach-pxa/mainstone.c b/arch/arm/mach-pxa/mainstone.c
index 02e188d..b307f11 100644
--- a/arch/arm/mach-pxa/mainstone.c
+++ b/arch/arm/mach-pxa/mainstone.c
@@ -493,6 +493,7 @@
MACHINE_START(MAINSTONE, "Intel HCDDBBVA0 Development Platform (aka Mainstone)")
/* Maintainer: MontaVista Software Inc. */
.phys_io = 0x40000000,
+ .boot_params = 0xa0000100, /* BLOB boot parameter setting */
.io_pg_offst = (io_p2v(0x40000000) >> 18) & 0xfffc,
.map_io = mainstone_map_io,
.init_irq = mainstone_init_irq,
diff --git a/arch/arm/mach-s3c2410/Kconfig b/arch/arm/mach-s3c2410/Kconfig
index ce7d810..970f98d 100644
--- a/arch/arm/mach-s3c2410/Kconfig
+++ b/arch/arm/mach-s3c2410/Kconfig
@@ -170,7 +170,7 @@
depends on ARCH_S3C2410 && PM
help
Say Y here if you want verbose debugging from the PM Suspend and
- Resume code. See `Documentation/arm/Samsing-S3C24XX/Suspend.txt`
+ Resume code. See <file:Documentation/arm/Samsung-S3C24XX/Suspend.txt>
for more information.
config S3C2410_PM_CHECK