| # |
| # USB Imageing devices configuration |
| # |
| comment "USB Imaging devices" |
| depends on USB |
| |
| config USB_MDC800 |
| tristate "USB Mustek MDC800 Digital Camera support (EXPERIMENTAL)" |
| depends on USB && EXPERIMENTAL |
| ---help--- |
| Say Y here if you want to connect this type of still camera to |
| your computer's USB port. This driver can be used with gphoto 0.4.3 |
| and higher (look at <http://www.gphoto.org/>). |
| To use it create a device node with "mknod /dev/mustek c 180 32" and |
| configure it in your software. |
| |
| To compile this driver as a module, choose M here: the |
| module will be called mdc800. |
| |
| config USB_MICROTEK |
| tristate "Microtek X6USB scanner support" |
| depends on USB && SCSI |
| help |
| Say Y here if you want support for the Microtek X6USB and |
| possibly the Phantom 336CX, Phantom C6 and ScanMaker V6U(S)L. |
| Support for anything but the X6 is experimental. |
| Please report failures and successes. |
| The scanner will appear as a scsi generic device to the rest |
| of the system. Scsi support is required. |
| This driver can be compiled as a module, called microtek. |