Linux-2.6.12-rc2
Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.
Let it rip!
diff --git a/drivers/pcmcia/ricoh.h b/drivers/pcmcia/ricoh.h
new file mode 100644
index 0000000..01098c8
--- /dev/null
+++ b/drivers/pcmcia/ricoh.h
@@ -0,0 +1,206 @@
+/*
+ * ricoh.h 1.9 1999/10/25 20:03:34
+ *
+ * The contents of this file are subject to the Mozilla Public License
+ * Version 1.1 (the "License"); you may not use this file except in
+ * compliance with the License. You may obtain a copy of the License
+ * at http://www.mozilla.org/MPL/
+ *
+ * Software distributed under the License is distributed on an "AS IS"
+ * basis, WITHOUT WARRANTY OF ANY KIND, either express or implied. See
+ * the License for the specific language governing rights and
+ * limitations under the License.
+ *
+ * The initial developer of the original code is David A. Hinds
+ * <dahinds@users.sourceforge.net>. Portions created by David A. Hinds
+ * are Copyright (C) 1999 David A. Hinds. All Rights Reserved.
+ *
+ * Alternatively, the contents of this file may be used under the
+ * terms of the GNU General Public License version 2 (the "GPL"), in which
+ * case the provisions of the GPL are applicable instead of the
+ * above. If you wish to allow the use of your version of this file
+ * only under the terms of the GPL and not to allow others to use
+ * your version of this file under the MPL, indicate your decision by
+ * deleting the provisions above and replace them with the notice and
+ * other provisions required by the GPL. If you do not delete the
+ * provisions above, a recipient may use your version of this file
+ * under either the MPL or the GPL.
+ */
+
+#ifndef _LINUX_RICOH_H
+#define _LINUX_RICOH_H
+
+
+#define RF5C_MODE_CTL 0x1f /* Mode control */
+#define RF5C_PWR_CTL 0x2f /* Mixed voltage control */
+#define RF5C_CHIP_ID 0x3a /* Chip identification */
+#define RF5C_MODE_CTL_3 0x3b /* Mode control 3 */
+
+/* I/O window address offset */
+#define RF5C_IO_OFF(w) (0x36+((w)<<1))
+
+/* Flags for RF5C_MODE_CTL */
+#define RF5C_MODE_ATA 0x01 /* ATA mode */
+#define RF5C_MODE_LED_ENA 0x02 /* IRQ 12 is LED */
+#define RF5C_MODE_CA21 0x04
+#define RF5C_MODE_CA22 0x08
+#define RF5C_MODE_CA23 0x10
+#define RF5C_MODE_CA24 0x20
+#define RF5C_MODE_CA25 0x40
+#define RF5C_MODE_3STATE_BIT7 0x80
+
+/* Flags for RF5C_PWR_CTL */
+#define RF5C_PWR_VCC_3V 0x01
+#define RF5C_PWR_IREQ_HIGH 0x02
+#define RF5C_PWR_INPACK_ENA 0x04
+#define RF5C_PWR_5V_DET 0x08
+#define RF5C_PWR_TC_SEL 0x10 /* Terminal Count: irq 11 or 15 */
+#define RF5C_PWR_DREQ_LOW 0x20
+#define RF5C_PWR_DREQ_OFF 0x00 /* DREQ steering control */
+#define RF5C_PWR_DREQ_INPACK 0x40
+#define RF5C_PWR_DREQ_SPKR 0x80
+#define RF5C_PWR_DREQ_IOIS16 0xc0
+
+/* Values for RF5C_CHIP_ID */
+#define RF5C_CHIP_RF5C296 0x32
+#define RF5C_CHIP_RF5C396 0xb2
+
+/* Flags for RF5C_MODE_CTL_3 */
+#define RF5C_MCTL3_DISABLE 0x01 /* Disable PCMCIA interface */
+#define RF5C_MCTL3_DMA_ENA 0x02
+
+/* Register definitions for Ricoh PCI-to-CardBus bridges */
+
+/* Extra bits in CB_BRIDGE_CONTROL */
+#define RL5C46X_BCR_3E0_ENA 0x0800
+#define RL5C46X_BCR_3E2_ENA 0x1000
+
+/* Bridge Configuration Register */
+#define RL5C4XX_CONFIG 0x80 /* 16 bit */
+#define RL5C4XX_CONFIG_IO_1_MODE 0x0200
+#define RL5C4XX_CONFIG_IO_0_MODE 0x0100
+#define RL5C4XX_CONFIG_PREFETCH 0x0001
+
+/* Misc Control Register */
+#define RL5C4XX_MISC 0x0082 /* 16 bit */
+#define RL5C4XX_MISC_HW_SUSPEND_ENA 0x0002
+#define RL5C4XX_MISC_VCCEN_POL 0x0100
+#define RL5C4XX_MISC_VPPEN_POL 0x0200
+#define RL5C46X_MISC_SUSPEND 0x0001
+#define RL5C46X_MISC_PWR_SAVE_2 0x0004
+#define RL5C46X_MISC_IFACE_BUSY 0x0008
+#define RL5C46X_MISC_B_LOCK 0x0010
+#define RL5C46X_MISC_A_LOCK 0x0020
+#define RL5C46X_MISC_PCI_LOCK 0x0040
+#define RL5C47X_MISC_IFACE_BUSY 0x0004
+#define RL5C47X_MISC_PCI_INT_MASK 0x0018
+#define RL5C47X_MISC_PCI_INT_DIS 0x0020
+#define RL5C47X_MISC_SUBSYS_WR 0x0040
+#define RL5C47X_MISC_SRIRQ_ENA 0x0080
+#define RL5C47X_MISC_5V_DISABLE 0x0400
+#define RL5C47X_MISC_LED_POL 0x0800
+
+/* 16-bit Interface Control Register */
+#define RL5C4XX_16BIT_CTL 0x0084 /* 16 bit */
+#define RL5C4XX_16CTL_IO_TIMING 0x0100
+#define RL5C4XX_16CTL_MEM_TIMING 0x0200
+#define RL5C46X_16CTL_LEVEL_1 0x0010
+#define RL5C46X_16CTL_LEVEL_2 0x0020
+
+/* 16-bit IO and memory timing registers */
+#define RL5C4XX_16BIT_IO_0 0x0088 /* 16 bit */
+#define RL5C4XX_16BIT_MEM_0 0x008a /* 16 bit */
+#define RL5C4XX_SETUP_MASK 0x0007
+#define RL5C4XX_SETUP_SHIFT 0
+#define RL5C4XX_CMD_MASK 0x01f0
+#define RL5C4XX_CMD_SHIFT 4
+#define RL5C4XX_HOLD_MASK 0x1c00
+#define RL5C4XX_HOLD_SHIFT 10
+#define RL5C4XX_MISC_CONTROL 0x2F /* 8 bit */
+#define RL5C4XX_ZV_ENABLE 0x08
+
+#ifdef __YENTA_H
+
+#define rl_misc(socket) ((socket)->private[0])
+#define rl_ctl(socket) ((socket)->private[1])
+#define rl_io(socket) ((socket)->private[2])
+#define rl_mem(socket) ((socket)->private[3])
+#define rl_config(socket) ((socket)->private[4])
+
+static void ricoh_zoom_video(struct pcmcia_socket *sock, int onoff)
+{
+ u8 reg;
+ struct yenta_socket *socket = container_of(sock, struct yenta_socket, socket);
+
+ reg = config_readb(socket, RL5C4XX_MISC_CONTROL);
+ if (onoff)
+ /* Zoom zoom, we will all go together, zoom zoom, zoom zoom */
+ reg |= RL5C4XX_ZV_ENABLE;
+ else
+ reg &= ~RL5C4XX_ZV_ENABLE;
+
+ config_writeb(socket, RL5C4XX_MISC_CONTROL, reg);
+}
+
+static void ricoh_set_zv(struct yenta_socket *socket)
+{
+ if(socket->dev->vendor == PCI_VENDOR_ID_RICOH)
+ {
+ switch(socket->dev->device)
+ {
+ /* There may be more .. */
+ case PCI_DEVICE_ID_RICOH_RL5C478:
+ socket->socket.zoom_video = ricoh_zoom_video;
+ break;
+ }
+ }
+}
+
+static void ricoh_save_state(struct yenta_socket *socket)
+{
+ rl_misc(socket) = config_readw(socket, RL5C4XX_MISC);
+ rl_ctl(socket) = config_readw(socket, RL5C4XX_16BIT_CTL);
+ rl_io(socket) = config_readw(socket, RL5C4XX_16BIT_IO_0);
+ rl_mem(socket) = config_readw(socket, RL5C4XX_16BIT_MEM_0);
+ rl_config(socket) = config_readw(socket, RL5C4XX_CONFIG);
+}
+
+static void ricoh_restore_state(struct yenta_socket *socket)
+{
+ config_writew(socket, RL5C4XX_MISC, rl_misc(socket));
+ config_writew(socket, RL5C4XX_16BIT_CTL, rl_ctl(socket));
+ config_writew(socket, RL5C4XX_16BIT_IO_0, rl_io(socket));
+ config_writew(socket, RL5C4XX_16BIT_MEM_0, rl_mem(socket));
+ config_writew(socket, RL5C4XX_CONFIG, rl_config(socket));
+}
+
+
+/*
+ * Magic Ricoh initialization code..
+ */
+static int ricoh_override(struct yenta_socket *socket)
+{
+ u16 config, ctl;
+
+ config = config_readw(socket, RL5C4XX_CONFIG);
+
+ /* Set the default timings, don't trust the original values */
+ ctl = RL5C4XX_16CTL_IO_TIMING | RL5C4XX_16CTL_MEM_TIMING;
+
+ if(socket->dev->device < PCI_DEVICE_ID_RICOH_RL5C475) {
+ ctl |= RL5C46X_16CTL_LEVEL_1 | RL5C46X_16CTL_LEVEL_2;
+ } else {
+ config |= RL5C4XX_CONFIG_PREFETCH;
+ }
+
+ config_writew(socket, RL5C4XX_16BIT_CTL, ctl);
+ config_writew(socket, RL5C4XX_CONFIG, config);
+
+ ricoh_set_zv(socket);
+
+ return 0;
+}
+
+#endif /* CONFIG_CARDBUS */
+
+#endif /* _LINUX_RICOH_H */