Linux-2.6.12-rc2
Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.
Let it rip!
diff --git a/drivers/scsi/sata_uli.c b/drivers/scsi/sata_uli.c
new file mode 100644
index 0000000..0bff4f4
--- /dev/null
+++ b/drivers/scsi/sata_uli.c
@@ -0,0 +1,287 @@
+/*
+ * sata_uli.c - ULi Electronics SATA
+ *
+ * The contents of this file are subject to the Open
+ * Software License version 1.1 that can be found at
+ * http://www.opensource.org/licenses/osl-1.1.txt and is included herein
+ * by reference.
+ *
+ * Alternatively, the contents of this file may be used under the terms
+ * of the GNU General Public License version 2 (the "GPL") as distributed
+ * in the kernel source COPYING file, in which case the provisions of
+ * the GPL are applicable instead of the above. If you wish to allow
+ * the use of your version of this file only under the terms of the
+ * GPL and not to allow others to use your version of this file under
+ * the OSL, indicate your decision by deleting the provisions above and
+ * replace them with the notice and other provisions required by the GPL.
+ * If you do not delete the provisions above, a recipient may use your
+ * version of this file under either the OSL or the GPL.
+ *
+ */
+
+#include <linux/config.h>
+#include <linux/kernel.h>
+#include <linux/module.h>
+#include <linux/pci.h>
+#include <linux/init.h>
+#include <linux/blkdev.h>
+#include <linux/delay.h>
+#include <linux/interrupt.h>
+#include "scsi.h"
+#include <scsi/scsi_host.h>
+#include <linux/libata.h>
+
+#define DRV_NAME "sata_uli"
+#define DRV_VERSION "0.5"
+
+enum {
+ uli_5289 = 0,
+ uli_5287 = 1,
+ uli_5281 = 2,
+
+ /* PCI configuration registers */
+ ULI5287_BASE = 0x90, /* sata0 phy SCR registers */
+ ULI5287_OFFS = 0x10, /* offset from sata0->sata1 phy regs */
+ ULI5281_BASE = 0x60, /* sata0 phy SCR registers */
+ ULI5281_OFFS = 0x60, /* offset from sata0->sata1 phy regs */
+};
+
+static int uli_init_one (struct pci_dev *pdev, const struct pci_device_id *ent);
+static u32 uli_scr_read (struct ata_port *ap, unsigned int sc_reg);
+static void uli_scr_write (struct ata_port *ap, unsigned int sc_reg, u32 val);
+
+static struct pci_device_id uli_pci_tbl[] = {
+ { PCI_VENDOR_ID_AL, 0x5289, PCI_ANY_ID, PCI_ANY_ID, 0, 0, uli_5289 },
+ { PCI_VENDOR_ID_AL, 0x5287, PCI_ANY_ID, PCI_ANY_ID, 0, 0, uli_5287 },
+ { PCI_VENDOR_ID_AL, 0x5281, PCI_ANY_ID, PCI_ANY_ID, 0, 0, uli_5281 },
+ { } /* terminate list */
+};
+
+
+static struct pci_driver uli_pci_driver = {
+ .name = DRV_NAME,
+ .id_table = uli_pci_tbl,
+ .probe = uli_init_one,
+ .remove = ata_pci_remove_one,
+};
+
+static Scsi_Host_Template uli_sht = {
+ .module = THIS_MODULE,
+ .name = DRV_NAME,
+ .ioctl = ata_scsi_ioctl,
+ .queuecommand = ata_scsi_queuecmd,
+ .eh_strategy_handler = ata_scsi_error,
+ .can_queue = ATA_DEF_QUEUE,
+ .this_id = ATA_SHT_THIS_ID,
+ .sg_tablesize = LIBATA_MAX_PRD,
+ .max_sectors = ATA_MAX_SECTORS,
+ .cmd_per_lun = ATA_SHT_CMD_PER_LUN,
+ .emulated = ATA_SHT_EMULATED,
+ .use_clustering = ATA_SHT_USE_CLUSTERING,
+ .proc_name = DRV_NAME,
+ .dma_boundary = ATA_DMA_BOUNDARY,
+ .slave_configure = ata_scsi_slave_config,
+ .bios_param = ata_std_bios_param,
+ .ordered_flush = 1,
+};
+
+static struct ata_port_operations uli_ops = {
+ .port_disable = ata_port_disable,
+
+ .tf_load = ata_tf_load,
+ .tf_read = ata_tf_read,
+ .check_status = ata_check_status,
+ .exec_command = ata_exec_command,
+ .dev_select = ata_std_dev_select,
+
+ .phy_reset = sata_phy_reset,
+
+ .bmdma_setup = ata_bmdma_setup,
+ .bmdma_start = ata_bmdma_start,
+ .bmdma_stop = ata_bmdma_stop,
+ .bmdma_status = ata_bmdma_status,
+ .qc_prep = ata_qc_prep,
+ .qc_issue = ata_qc_issue_prot,
+
+ .eng_timeout = ata_eng_timeout,
+
+ .irq_handler = ata_interrupt,
+ .irq_clear = ata_bmdma_irq_clear,
+
+ .scr_read = uli_scr_read,
+ .scr_write = uli_scr_write,
+
+ .port_start = ata_port_start,
+ .port_stop = ata_port_stop,
+};
+
+static struct ata_port_info uli_port_info = {
+ .sht = &uli_sht,
+ .host_flags = ATA_FLAG_SATA | ATA_FLAG_SATA_RESET |
+ ATA_FLAG_NO_LEGACY,
+ .pio_mask = 0x03, //support pio mode 4 (FIXME)
+ .udma_mask = 0x7f, //support udma mode 6
+ .port_ops = &uli_ops,
+};
+
+
+MODULE_AUTHOR("Peer Chen");
+MODULE_DESCRIPTION("low-level driver for ULi Electronics SATA controller");
+MODULE_LICENSE("GPL");
+MODULE_DEVICE_TABLE(pci, uli_pci_tbl);
+MODULE_VERSION(DRV_VERSION);
+
+static unsigned int get_scr_cfg_addr(struct ata_port *ap, unsigned int sc_reg)
+{
+ return ap->ioaddr.scr_addr + (4 * sc_reg);
+}
+
+static u32 uli_scr_cfg_read (struct ata_port *ap, unsigned int sc_reg)
+{
+ struct pci_dev *pdev = to_pci_dev(ap->host_set->dev);
+ unsigned int cfg_addr = get_scr_cfg_addr(ap, sc_reg);
+ u32 val;
+
+ pci_read_config_dword(pdev, cfg_addr, &val);
+ return val;
+}
+
+static void uli_scr_cfg_write (struct ata_port *ap, unsigned int scr, u32 val)
+{
+ struct pci_dev *pdev = to_pci_dev(ap->host_set->dev);
+ unsigned int cfg_addr = get_scr_cfg_addr(ap, scr);
+
+ pci_write_config_dword(pdev, cfg_addr, val);
+}
+
+static u32 uli_scr_read (struct ata_port *ap, unsigned int sc_reg)
+{
+ if (sc_reg > SCR_CONTROL)
+ return 0xffffffffU;
+
+ return uli_scr_cfg_read(ap, sc_reg);
+}
+
+static void uli_scr_write (struct ata_port *ap, unsigned int sc_reg, u32 val)
+{
+ if (sc_reg > SCR_CONTROL) //SCR_CONTROL=2, SCR_ERROR=1, SCR_STATUS=0
+ return;
+
+ uli_scr_cfg_write(ap, sc_reg, val);
+}
+
+/* move to PCI layer, integrate w/ MSI stuff */
+static void pci_enable_intx(struct pci_dev *pdev)
+{
+ u16 pci_command;
+
+ pci_read_config_word(pdev, PCI_COMMAND, &pci_command);
+ if (pci_command & PCI_COMMAND_INTX_DISABLE) {
+ pci_command &= ~PCI_COMMAND_INTX_DISABLE;
+ pci_write_config_word(pdev, PCI_COMMAND, pci_command);
+ }
+}
+
+static int uli_init_one (struct pci_dev *pdev, const struct pci_device_id *ent)
+{
+ struct ata_probe_ent *probe_ent;
+ struct ata_port_info *ppi;
+ int rc;
+ unsigned int board_idx = (unsigned int) ent->driver_data;
+ int pci_dev_busy = 0;
+
+ rc = pci_enable_device(pdev);
+ if (rc)
+ return rc;
+
+ rc = pci_request_regions(pdev, DRV_NAME);
+ if (rc) {
+ pci_dev_busy = 1;
+ goto err_out;
+ }
+
+ rc = pci_set_dma_mask(pdev, ATA_DMA_MASK);
+ if (rc)
+ goto err_out_regions;
+ rc = pci_set_consistent_dma_mask(pdev, ATA_DMA_MASK);
+ if (rc)
+ goto err_out_regions;
+
+ ppi = &uli_port_info;
+ probe_ent = ata_pci_init_native_mode(pdev, &ppi);
+ if (!probe_ent) {
+ rc = -ENOMEM;
+ goto err_out_regions;
+ }
+
+ switch (board_idx) {
+ case uli_5287:
+ probe_ent->port[0].scr_addr = ULI5287_BASE;
+ probe_ent->port[1].scr_addr = ULI5287_BASE + ULI5287_OFFS;
+ probe_ent->n_ports = 4;
+
+ probe_ent->port[2].cmd_addr = pci_resource_start(pdev, 0) + 8;
+ probe_ent->port[2].altstatus_addr =
+ probe_ent->port[2].ctl_addr =
+ (pci_resource_start(pdev, 1) | ATA_PCI_CTL_OFS) + 4;
+ probe_ent->port[2].bmdma_addr = pci_resource_start(pdev, 4) + 16;
+ probe_ent->port[2].scr_addr = ULI5287_BASE + ULI5287_OFFS*4;
+
+ probe_ent->port[3].cmd_addr = pci_resource_start(pdev, 2) + 8;
+ probe_ent->port[3].altstatus_addr =
+ probe_ent->port[3].ctl_addr =
+ (pci_resource_start(pdev, 3) | ATA_PCI_CTL_OFS) + 4;
+ probe_ent->port[3].bmdma_addr = pci_resource_start(pdev, 4) + 24;
+ probe_ent->port[3].scr_addr = ULI5287_BASE + ULI5287_OFFS*5;
+
+ ata_std_ports(&probe_ent->port[2]);
+ ata_std_ports(&probe_ent->port[3]);
+ break;
+
+ case uli_5289:
+ probe_ent->port[0].scr_addr = ULI5287_BASE;
+ probe_ent->port[1].scr_addr = ULI5287_BASE + ULI5287_OFFS;
+ break;
+
+ case uli_5281:
+ probe_ent->port[0].scr_addr = ULI5281_BASE;
+ probe_ent->port[1].scr_addr = ULI5281_BASE + ULI5281_OFFS;
+ break;
+
+ default:
+ BUG();
+ break;
+ }
+
+ pci_set_master(pdev);
+ pci_enable_intx(pdev);
+
+ /* FIXME: check ata_device_add return value */
+ ata_device_add(probe_ent);
+ kfree(probe_ent);
+
+ return 0;
+
+err_out_regions:
+ pci_release_regions(pdev);
+
+err_out:
+ if (!pci_dev_busy)
+ pci_disable_device(pdev);
+ return rc;
+
+}
+
+static int __init uli_init(void)
+{
+ return pci_module_init(&uli_pci_driver);
+}
+
+static void __exit uli_exit(void)
+{
+ pci_unregister_driver(&uli_pci_driver);
+}
+
+
+module_init(uli_init);
+module_exit(uli_exit);