Linux-2.6.12-rc2
Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.
Let it rip!
diff --git a/include/asm-sparc/auxio.h b/include/asm-sparc/auxio.h
new file mode 100644
index 0000000..ee83aef
--- /dev/null
+++ b/include/asm-sparc/auxio.h
@@ -0,0 +1,89 @@
+/* $Id: auxio.h,v 1.18 1997/11/07 15:01:45 jj Exp $
+ * auxio.h: Definitions and code for the Auxiliary I/O register.
+ *
+ * Copyright (C) 1995 David S. Miller (davem@caip.rutgers.edu)
+ */
+#ifndef _SPARC_AUXIO_H
+#define _SPARC_AUXIO_H
+
+#include <asm/system.h>
+#include <asm/vaddrs.h>
+
+/* This register is an unsigned char in IO space. It does two things.
+ * First, it is used to control the front panel LED light on machines
+ * that have it (good for testing entry points to trap handlers and irq's)
+ * Secondly, it controls various floppy drive parameters.
+ */
+#define AUXIO_ORMEIN 0xf0 /* All writes must set these bits. */
+#define AUXIO_ORMEIN4M 0xc0 /* sun4m - All writes must set these bits. */
+#define AUXIO_FLPY_DENS 0x20 /* Floppy density, high if set. Read only. */
+#define AUXIO_FLPY_DCHG 0x10 /* A disk change occurred. Read only. */
+#define AUXIO_EDGE_ON 0x10 /* sun4m - On means Jumper block is in. */
+#define AUXIO_FLPY_DSEL 0x08 /* Drive select/start-motor. Write only. */
+#define AUXIO_LINK_TEST 0x08 /* sun4m - On means TPE Carrier detect. */
+
+/* Set the following to one, then zero, after doing a pseudo DMA transfer. */
+#define AUXIO_FLPY_TCNT 0x04 /* Floppy terminal count. Write only. */
+
+/* Set the following to zero to eject the floppy. */
+#define AUXIO_FLPY_EJCT 0x02 /* Eject floppy disk. Write only. */
+#define AUXIO_LED 0x01 /* On if set, off if unset. Read/Write */
+
+#ifndef __ASSEMBLY__
+
+/*
+ * NOTE: these routines are implementation dependent--
+ * understand the hardware you are querying!
+ */
+extern void set_auxio(unsigned char bits_on, unsigned char bits_off);
+extern unsigned char get_auxio(void); /* .../asm-sparc/floppy.h */
+
+/*
+ * The following routines are provided for driver-compatibility
+ * with sparc64 (primarily sunlance.c)
+ */
+
+#define AUXIO_LTE_ON 1
+#define AUXIO_LTE_OFF 0
+
+/* auxio_set_lte - Set Link Test Enable (TPE Link Detect)
+ *
+ * on - AUXIO_LTE_ON or AUXIO_LTE_OFF
+ */
+#define auxio_set_lte(on) \
+do { \
+ if(on) { \
+ set_auxio(AUXIO_LINK_TEST, 0); \
+ } else { \
+ set_auxio(0, AUXIO_LINK_TEST); \
+ } \
+} while (0)
+
+#define AUXIO_LED_ON 1
+#define AUXIO_LED_OFF 0
+
+/* auxio_set_led - Set system front panel LED
+ *
+ * on - AUXIO_LED_ON or AUXIO_LED_OFF
+ */
+#define auxio_set_led(on) \
+do { \
+ if(on) { \
+ set_auxio(AUXIO_LED, 0); \
+ } else { \
+ set_auxio(0, AUXIO_LED); \
+ } \
+} while (0)
+
+#endif /* !(__ASSEMBLY__) */
+
+
+/* AUXIO2 (Power Off Control) */
+extern __volatile__ unsigned char * auxio_power_register;
+
+#define AUXIO_POWER_DETECT_FAILURE 32
+#define AUXIO_POWER_CLEAR_FAILURE 2
+#define AUXIO_POWER_OFF 1
+
+
+#endif /* !(_SPARC_AUXIO_H) */