tree 420215f0876bc9cf3da5a21e5c5904611f821faa
parent d02859ecb321c8c0f74cb9bbe3f51a59e58822b0
author Jeremy Fitzhardinge <jeremy@goop.org> 1213615800 -0700
committer Ingo Molnar <mingo@elte.hu> 1214399753 +0200

mm: add a ptep_modify_prot transaction abstraction

This patch adds an API for doing read-modify-write updates to a pte's
protection bits which may race against hardware updates to the pte.
After reading the pte, the hardware may asynchonously set the accessed
or dirty bits on a pte, which would be lost when writing back the
modified pte value.

The existing technique to handle this race is to use
ptep_get_and_clear() atomically fetch the old pte value and clear it
in memory.  This has the effect of marking the pte as non-present,
which will prevent the hardware from updating its state.  When the new
value is written back, the pte will be present again, and the hardware
can resume updating the access/dirty flags.

When running in a virtualized environment, pagetable updates are
relatively expensive, since they generally involve some trap into the
hypervisor.  To mitigate the cost of these updates, we tend to batch
them.

However, because of the atomic nature of ptep_get_and_clear(), it is
inherently non-batchable.  This new interface allows batching by
giving the underlying implementation enough information to open a
transaction between the read and write phases:

ptep_modify_prot_start() returns the current pte value, and puts the
  pte entry into a state where either the hardware will not update the
  pte, or if it does, the updates will be preserved on commit.

ptep_modify_prot_commit() writes back the updated pte, makes sure that
  any hardware updates made since ptep_modify_prot_start() are
  preserved.

ptep_modify_prot_start() and _commit() must be exactly paired, and
used while holding the appropriate pte lock.  They do not protect
against other software updates of the pte in any way.

The current implementations of ptep_modify_prot_start and _commit are
functionally unchanged from before: _start() uses ptep_get_and_clear()
fetch the pte and zero the entry, preventing any hardware updates.
_commit() simply writes the new pte value back knowing that the
hardware has not updated the pte in the meantime.

The only current user of this interface is mprotect

Signed-off-by: Jeremy Fitzhardinge <jeremy.fitzhardinge@citrix.com>
Acked-by: Linus Torvalds <torvalds@linux-foundation.org>
Acked-by: Hugh Dickins <hugh@veritas.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>