tree 8491b9b8b3bbb55d250c8817ebf620ba5d8894f9
parent 67a3e12b05e055c0415c556a315a3d3eb637e29e
author Janusz Krzysztofik <jkrzyszt@tis.icnet.pl> 1274059213 +0200
committer Tomi Valkeinen <tomi.valkeinen@nokia.com> 1276586239 +0300

OMAPFB: LCDC: change update_mode to DISABLED when going suspend

I was observing the following error messages on my OMAP1 based Amstrad Delta
board when first changing from text to graphics mode or vice versa after the
LCD display had been blanked:
	omapfb omapfb: timeout waiting for FRAME DONE
with a followup error message while unblanking it back:
	omapfb omapfb: resetting (status 0xffffffb2,reset count 1)
As a visible result, image pixels happened to be shifted by a few bits,
giving wrong colors.

Examining the code, I found that this problem occures when an OMAP1 internal
LCD controller is disabled from omap_lcdc_suspend() and then a subsequent
omap_lcdc_setup_plane() calls disable_controller() again. This potentially
error provoking behaviour is triggered by the lcdc.update_mode flag being kept
at OMAP_AUTO_UPDATE, regardless of the controller and panel being suspended.

This patch tries to correct the problem by replacing both omap_lcdc_suspend()
and omap_lcdc_resume() function bodies with single calls to
omap_lcdc_set_update_mode() with a respective OMAP_UPDATE_DISABLE or
OMAP_AUTO_UPDATE argument. As a result, exactly the same lower level
operations are performed, with addition of changing the lcdc.update_mode flag
to a value better suited for the controller state. This prevents any further
calls to disable_controller() from omap_lcdc_setup_plane() while the display
is suspended.

Created against linux-2.6.34-rc7.
Tested on Amstrad Delta.

Signed-off-by: Janusz Krzysztofik <jkrzyszt@tis.icnet.pl>
Signed-off-by: Tomi Valkeinen <tomi.valkeinen@nokia.com>