Fix common misspellings
Fixes generated by 'codespell' and manually reviewed.
Signed-off-by: Lucas De Marchi <lucas.demarchi@profusion.mobi>
diff --git a/drivers/usb/host/Kconfig b/drivers/usb/host/Kconfig
index 9483acd..e0e0787 100644
--- a/drivers/usb/host/Kconfig
+++ b/drivers/usb/host/Kconfig
@@ -402,7 +402,7 @@
depends on USB_FHCI_HCD && DEBUG_FS
help
Say "y" to see some FHCI debug information and statistics
- throught debugfs.
+ through debugfs.
config USB_U132_HCD
tristate "Elan U132 Adapter Host Controller"
diff --git a/drivers/usb/host/ehci.h b/drivers/usb/host/ehci.h
index f86d3fa..333ddc1 100644
--- a/drivers/usb/host/ehci.h
+++ b/drivers/usb/host/ehci.h
@@ -644,7 +644,7 @@
/*
* On certain ppc-44x SoC there is a HW issue, that could only worked around with
* explicit suspend/operate of OHCI. This function hereby makes sense only on that arch.
- * Other common bits are dependant on has_amcc_usb23 quirk flag.
+ * Other common bits are dependent on has_amcc_usb23 quirk flag.
*/
#ifdef CONFIG_44x
static inline void set_ohci_hcfs(struct ehci_hcd *ehci, int operational)
diff --git a/drivers/usb/host/fhci-hcd.c b/drivers/usb/host/fhci-hcd.c
index b84ff7e..19223c7 100644
--- a/drivers/usb/host/fhci-hcd.c
+++ b/drivers/usb/host/fhci-hcd.c
@@ -401,7 +401,7 @@
/* 1 td fro setup,1 for ack */
size = 2;
case PIPE_BULK:
- /* one td for every 4096 bytes(can be upto 8k) */
+ /* one td for every 4096 bytes(can be up to 8k) */
size += urb->transfer_buffer_length / 4096;
/* ...add for any remaining bytes... */
if ((urb->transfer_buffer_length % 4096) != 0)
diff --git a/drivers/usb/host/fhci-tds.c b/drivers/usb/host/fhci-tds.c
index 38fe058..0ea577b 100644
--- a/drivers/usb/host/fhci-tds.c
+++ b/drivers/usb/host/fhci-tds.c
@@ -40,7 +40,7 @@
#define TD_RXER 0x0020 /* Rx error or not */
#define TD_NAK 0x0010 /* No ack. */
-#define TD_STAL 0x0008 /* Stall recieved */
+#define TD_STAL 0x0008 /* Stall received */
#define TD_TO 0x0004 /* time out */
#define TD_UN 0x0002 /* underrun */
#define TD_NO 0x0010 /* Rx Non Octet Aligned Packet */
@@ -274,7 +274,7 @@
* It is also preparing the TDs for new frames. If the Tx interrupts
* are disabled, the application should call that routine to get
* confirmation about the submitted frames. Otherwise, the routine is
- * called frome the interrupt service routine during the Tx interrupt.
+ * called from the interrupt service routine during the Tx interrupt.
* In that case the application is informed by calling the application
* specific 'fhci_transaction_confirm' routine
*/
@@ -337,7 +337,7 @@
pkt->status = USB_TD_RX_ER_NONOCT;
else
fhci_err(usb->fhci, "illegal error "
- "occured\n");
+ "occurred\n");
} else if (td_status & TD_NAK)
pkt->status = USB_TD_TX_ER_NAK;
else if (td_status & TD_TO)
@@ -347,7 +347,7 @@
else if (td_status & TD_STAL)
pkt->status = USB_TD_TX_ER_STALL;
else
- fhci_err(usb->fhci, "illegal error occured\n");
+ fhci_err(usb->fhci, "illegal error occurred\n");
} else if ((extra_data & TD_TOK_IN) &&
pkt->len > td_length - CRC_SIZE) {
pkt->status = USB_TD_RX_DATA_UNDERUN;
diff --git a/drivers/usb/host/fhci.h b/drivers/usb/host/fhci.h
index 71c3caa..dc6939a 100644
--- a/drivers/usb/host/fhci.h
+++ b/drivers/usb/host/fhci.h
@@ -82,7 +82,7 @@
#define USB_TD_RX_ER_NONOCT 0x40000000 /* Tx Non Octet Aligned Packet */
#define USB_TD_RX_ER_BITSTUFF 0x20000000 /* Frame Aborted-Received pkt */
#define USB_TD_RX_ER_CRC 0x10000000 /* CRC error */
-#define USB_TD_RX_ER_OVERUN 0x08000000 /* Over - run occured */
+#define USB_TD_RX_ER_OVERUN 0x08000000 /* Over - run occurred */
#define USB_TD_RX_ER_PID 0x04000000 /* wrong PID received */
#define USB_TD_RX_DATA_UNDERUN 0x02000000 /* shorter than expected */
#define USB_TD_RX_DATA_OVERUN 0x01000000 /* longer than expected */
@@ -363,7 +363,7 @@
struct td {
void *data; /* a pointer to the data buffer */
unsigned int len; /* length of the data to be submitted */
- unsigned int actual_len; /* actual bytes transfered on this td */
+ unsigned int actual_len; /* actual bytes transferred on this td */
enum fhci_ta_type type; /* transaction type */
u8 toggle; /* toggle for next trans. within this TD */
u16 iso_index; /* ISO transaction index */
diff --git a/drivers/usb/host/imx21-hcd.c b/drivers/usb/host/imx21-hcd.c
index 2562e92..af05718 100644
--- a/drivers/usb/host/imx21-hcd.c
+++ b/drivers/usb/host/imx21-hcd.c
@@ -1323,7 +1323,7 @@
* (and hence no interrupt occurs).
* This causes the transfer in question to hang.
* The kludge below checks for this condition at each SOF and processes any
- * blocked ETDs (after an arbitary 10 frame wait)
+ * blocked ETDs (after an arbitrary 10 frame wait)
*
* With a single active transfer the usbtest test suite will run for days
* without the kludge.
diff --git a/drivers/usb/host/isp116x.h b/drivers/usb/host/isp116x.h
index 12db961..9a2c400 100644
--- a/drivers/usb/host/isp116x.h
+++ b/drivers/usb/host/isp116x.h
@@ -13,7 +13,7 @@
/* Full speed: max # of bytes to transfer for a single urb
at a time must be < 1024 && must be multiple of 64.
- 832 allows transfering 4kiB within 5 frames. */
+ 832 allows transferring 4kiB within 5 frames. */
#define MAX_TRANSFER_SIZE_FULLSPEED 832
/* Low speed: there is no reason to schedule in very big
diff --git a/drivers/usb/host/isp1362-hcd.c b/drivers/usb/host/isp1362-hcd.c
index 662cd00..f97570a 100644
--- a/drivers/usb/host/isp1362-hcd.c
+++ b/drivers/usb/host/isp1362-hcd.c
@@ -546,7 +546,7 @@
if (usb_pipecontrol(urb->pipe)) {
ep->nextpid = USB_PID_ACK;
/* save the data underrun error code for later and
- * procede with the status stage
+ * proceed with the status stage
*/
urb->actual_length += PTD_GET_COUNT(ptd);
BUG_ON(urb->actual_length > urb->transfer_buffer_length);
diff --git a/drivers/usb/host/ohci-hcd.c b/drivers/usb/host/ohci-hcd.c
index e728863..d557235 100644
--- a/drivers/usb/host/ohci-hcd.c
+++ b/drivers/usb/host/ohci-hcd.c
@@ -162,7 +162,7 @@
// case PIPE_INTERRUPT:
// case PIPE_BULK:
default:
- /* one TD for every 4096 Bytes (can be upto 8K) */
+ /* one TD for every 4096 Bytes (can be up to 8K) */
size += urb->transfer_buffer_length / 4096;
/* ... and for any remaining bytes ... */
if ((urb->transfer_buffer_length % 4096) != 0)
diff --git a/drivers/usb/host/oxu210hp-hcd.c b/drivers/usb/host/oxu210hp-hcd.c
index 44e4deb..4a771f6 100644
--- a/drivers/usb/host/oxu210hp-hcd.c
+++ b/drivers/usb/host/oxu210hp-hcd.c
@@ -2879,7 +2879,7 @@
/* Ok, we have more job to do! :) */
for (i = 0; i < num - 1; i++) {
- /* Get free micro URB poll till a free urb is recieved */
+ /* Get free micro URB poll till a free urb is received */
do {
murb = (struct urb *) oxu_murb_alloc(oxu);
@@ -2911,7 +2911,7 @@
/* Last urb requires special handling */
- /* Get free micro URB poll till a free urb is recieved */
+ /* Get free micro URB poll till a free urb is received */
do {
murb = (struct urb *) oxu_murb_alloc(oxu);
if (!murb)
diff --git a/drivers/usb/host/whci/qset.c b/drivers/usb/host/whci/qset.c
index dc0ab83..d6e1754 100644
--- a/drivers/usb/host/whci/qset.c
+++ b/drivers/usb/host/whci/qset.c
@@ -739,7 +739,7 @@
* process_inactive_qtd - process an inactive (but not halted) qTD.
*
* Update the urb with the transfer bytes from the qTD, if the urb is
- * completely transfered or (in the case of an IN only) the LPF is
+ * completely transferred or (in the case of an IN only) the LPF is
* set, then the transfer is complete and the urb should be returned
* to the system.
*/
diff --git a/drivers/usb/host/xhci.c b/drivers/usb/host/xhci.c
index 9a3645f..196e018 100644
--- a/drivers/usb/host/xhci.c
+++ b/drivers/usb/host/xhci.c
@@ -741,7 +741,7 @@
int retval;
/* Wait a bit if either of the roothubs need to settle from the
- * transistion into bus suspend.
+ * transition into bus suspend.
*/
if (time_before(jiffies, xhci->bus_state[0].next_statechange) ||
time_before(jiffies,
@@ -2072,7 +2072,7 @@
return -EINVAL;
}
vdev = xhci->devs[udev->slot_id];
- /* Mark each endpoint as being in transistion, so
+ /* Mark each endpoint as being in transition, so
* xhci_urb_enqueue() will reject all URBs.
*/
for (i = 0; i < num_eps; i++) {
diff --git a/drivers/usb/host/xhci.h b/drivers/usb/host/xhci.h
index 711de25..07e2630 100644
--- a/drivers/usb/host/xhci.h
+++ b/drivers/usb/host/xhci.h
@@ -873,7 +873,7 @@
#define COMP_CMD_ABORT 25
/* Stopped - transfer was terminated by a stop endpoint command */
#define COMP_STOP 26
-/* Same as COMP_EP_STOPPED, but the transfered length in the event is invalid */
+/* Same as COMP_EP_STOPPED, but the transferred length in the event is invalid */
#define COMP_STOP_INVAL 27
/* Control Abort Error - Debug Capability - control pipe aborted */
#define COMP_DBG_ABORT 28