HID: Send Report ID when numbered reports are sent over the control endpoint.
The Report ID wasn't sent as part of the payload for reports which were sent
over the control endpoint. This is required by section 8.1 of the HID spec.
Signed-off-by: Alan Ott <alan@signal11.us>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
diff --git a/drivers/hid/usbhid/hid-core.c b/drivers/hid/usbhid/hid-core.c
index 1ebd324..b729c02 100644
--- a/drivers/hid/usbhid/hid-core.c
+++ b/drivers/hid/usbhid/hid-core.c
@@ -827,14 +827,21 @@
ret++;
}
} else {
+ int skipped_report_id = 0;
+ if (buf[0] == 0x0) {
+ /* Don't send the Report ID */
+ buf++;
+ count--;
+ skipped_report_id = 1;
+ }
ret = usb_control_msg(dev, usb_sndctrlpipe(dev, 0),
HID_REQ_SET_REPORT,
USB_DIR_OUT | USB_TYPE_CLASS | USB_RECIP_INTERFACE,
((report_type + 1) << 8) | *buf,
- interface->desc.bInterfaceNumber, buf + 1, count - 1,
+ interface->desc.bInterfaceNumber, buf, count,
USB_CTRL_SET_TIMEOUT);
- /* count also the report id */
- if (ret > 0)
+ /* count also the report id, if this was a numbered report. */
+ if (ret > 0 && skipped_report_id)
ret++;
}