sata_nv: add back some verbosity into ADMA error_handler
Some debug output in the ADMA error_handler function was removed recently,
but it may be useful in certain cases, like NCQ commands timing out. Add it
back in, but make it a bit more intelligent so that it only prints if
command(s) are active and only prints the CPBs for those commands.
That way it won't spew at inappropriate times like suspend/resume.
Signed-off-by: Robert Hancock <hancockr@shaw.ca>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/ata/sata_nv.c b/drivers/ata/sata_nv.c
index ab92f20..f1fea96 100644
--- a/drivers/ata/sata_nv.c
+++ b/drivers/ata/sata_nv.c
@@ -1446,6 +1446,26 @@
void __iomem *mmio = pp->ctl_block;
int i;
u16 tmp;
+
+ if(ata_tag_valid(ap->active_tag) || ap->sactive) {
+ u32 notifier = readl(mmio + NV_ADMA_NOTIFIER);
+ u32 notifier_error = readl(mmio + NV_ADMA_NOTIFIER_ERROR);
+ u32 gen_ctl = readl(pp->gen_block + NV_ADMA_GEN_CTL);
+ u32 status = readw(mmio + NV_ADMA_STAT);
+
+ ata_port_printk(ap, KERN_ERR, "EH in ADMA mode, notifier 0x%X "
+ "notifier_error 0x%X gen_ctl 0x%X status 0x%X\n",
+ notifier, notifier_error, gen_ctl, status);
+
+ for( i=0;i<NV_ADMA_MAX_CPBS;i++) {
+ struct nv_adma_cpb *cpb = &pp->cpb[i];
+ if( (ata_tag_valid(ap->active_tag) && i == ap->active_tag) ||
+ ap->sactive & (1 << i) )
+ ata_port_printk(ap, KERN_ERR,
+ "CPB %d: ctl_flags 0x%x, resp_flags 0x%x\n",
+ i, cpb->ctl_flags, cpb->resp_flags);
+ }
+ }
/* Push us back into port register mode for error handling. */
nv_adma_register_mode(ap);