[PATCH] ieee1394: reorder activities after bus reset (fixes device detection)

Units were not detected if the local IRM performed a bus reset.  ("The root
node is not cycle master capable; selecting a new root node and resetting...",
often seen with iPods and other SBP-2 devices).  Rearrange the order of IRM
duties and node scanning.  TODO: Audit the ROM caching and parsing code for
underlying issues.

Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>
Signed-off-by: Jody McIntyre <scjody@steamballoon.com>
Cc: Ben Collins <bcollins@debian.org>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
diff --git a/drivers/ieee1394/nodemgr.c b/drivers/ieee1394/nodemgr.c
index b233225..743f13c 100644
--- a/drivers/ieee1394/nodemgr.c
+++ b/drivers/ieee1394/nodemgr.c
@@ -1438,9 +1438,13 @@
 	if (host->busmgr_id == 0xffff && host->node_count > 1)
 	{
 		u16 root_node = host->node_count - 1;
-		struct node_entry *ne = find_entry_by_nodeid(host, root_node | LOCAL_BUS);
 
-		if (ne && ne->busopt.cmc)
+		/* get cycle master capability flag from root node */
+		if (host->is_cycmst ||
+		    (!hpsb_read(host, LOCAL_BUS | root_node, get_hpsb_generation(host),
+				(CSR_REGISTER_BASE + CSR_CONFIG_ROM + 2 * sizeof(quadlet_t)),
+				&bc, sizeof(quadlet_t)) &&
+		     be32_to_cpu(bc) & 1 << CSR_CMC_SHIFT))
 			hpsb_send_phy_config(host, root_node, -1);
 		else {
 			HPSB_DEBUG("The root node is not cycle master capable; "
@@ -1557,24 +1561,19 @@
 			}
 		}
 
-		if (!nodemgr_check_irm_capability(host, reset_cycles)) {
+		if (!nodemgr_check_irm_capability(host, reset_cycles) ||
+		    !nodemgr_do_irm_duties(host, reset_cycles)) {
 			reset_cycles++;
 			up(&nodemgr_serialize);
 			continue;
 		}
+		reset_cycles = 0;
 
 		/* Scan our nodes to get the bus options and create node
 		 * entries. This does not do the sysfs stuff, since that
 		 * would trigger hotplug callbacks and such, which is a
 		 * bad idea at this point. */
 		nodemgr_node_scan(hi, generation);
-		if (!nodemgr_do_irm_duties(host, reset_cycles)) {
-			reset_cycles++;
-			up(&nodemgr_serialize);
-			continue;
-		}
-
-		reset_cycles = 0;
 
 		/* This actually does the full probe, with sysfs
 		 * registration. */