[PATCH] sx: fix non-PCI build
When CONFIG_PCI is not defined (i.e. PCI bus is disabled), the sx driver
fails to link, since some pci functions are not available. Fix this
behaviour to be able to compile this driver on machines with no PCI bus
(but with ISA bus support).
Signed-off-by: Jiri Slaby <jirislaby@gmail.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
diff --git a/drivers/char/sx.c b/drivers/char/sx.c
index a3008ce..1da92a6 100644
--- a/drivers/char/sx.c
+++ b/drivers/char/sx.c
@@ -2498,8 +2498,10 @@
/* It is safe/allowed to del_timer a non-active timer */
del_timer(&board->timer);
if (pdev) {
+#ifdef CONFIG_PCI
pci_iounmap(pdev, board->base);
pci_release_region(pdev, IS_CF_BOARD(board) ? 3 : 2);
+#endif
} else {
iounmap(board->base);
release_region(board->hw_base, board->hw_len);
@@ -2601,6 +2603,7 @@
#endif
+#ifdef CONFIG_PCI
/********************************************************
* Setting bit 17 in the CNTRL register of the PLX 9050 *
* chip forces a retry on writes while a read is pending.*
@@ -2632,10 +2635,12 @@
}
iounmap(rebase);
}
+#endif
static int __devinit sx_pci_probe(struct pci_dev *pdev,
const struct pci_device_id *ent)
{
+#ifdef CONFIG_PCI
struct sx_board *board;
unsigned int i, reg;
int retval = -EIO;
@@ -2700,6 +2705,9 @@
board->flags &= ~SX_BOARD_PRESENT;
err:
return retval;
+#else
+ return -ENODEV;
+#endif
}
static void __devexit sx_pci_remove(struct pci_dev *pdev)