mac_scsi: dont enable mac_scsi irq before requesting it
Don't enable the SCSI irq when initialising the chip -- the irq has no
handler yet.
Signed-off-by: Finn Thain <fthain@telegraphics.com.au>
Signed-off-by: Geert Uytterhoeven <geert@linux-m68k.org>
diff --git a/drivers/scsi/mac_scsi.c b/drivers/scsi/mac_scsi.c
index af3a6af..737d526 100644
--- a/drivers/scsi/mac_scsi.c
+++ b/drivers/scsi/mac_scsi.c
@@ -340,9 +340,6 @@
printk(KERN_INFO "Macintosh SCSI: resetting the SCSI bus..." );
- /* switch off SCSI IRQ - catch an interrupt without IRQ bit set else */
- disable_irq(IRQ_MAC_SCSI);
-
/* get in phase */
NCR5380_write( TARGET_COMMAND_REG,
PHASE_SR_TO_TCR( NCR5380_read(STATUS_REG) ));
@@ -358,9 +355,6 @@
for( end = jiffies + AFTER_RESET_DELAY; time_before(jiffies, end); )
barrier();
- /* switch on SCSI IRQ again */
- enable_irq(IRQ_MAC_SCSI);
-
printk(KERN_INFO " done\n" );
}
#endif