md: avoid endless recovery loop when waiting for fail device to complete.
If a device fails in a way that causes pending request to take a while
to complete, md will not be able to immediately remove it from the
array in remove_and_add_spares.
It will then incorrectly look like a spare device and md will try to
recover it even though it is failed.
This leads to a recovery process starting and instantly aborting over
and over again.
We should check if the device is faulty before considering it to be a
spare. This will avoid trying to start a recovery that cannot
proceed.
This bug was introduced in 2.6.26 so that patch is suitable for any
kernel since then.
Cc: stable@kernel.org
Reported-by: Jim Paradis <james.paradis@stratus.com>
Signed-off-by: NeilBrown <neilb@suse.de>
diff --git a/drivers/md/md.c b/drivers/md/md.c
index 4332fc2..91e31e2 100644
--- a/drivers/md/md.c
+++ b/drivers/md/md.c
@@ -7088,6 +7088,7 @@
list_for_each_entry(rdev, &mddev->disks, same_set) {
if (rdev->raid_disk >= 0 &&
!test_bit(In_sync, &rdev->flags) &&
+ !test_bit(Faulty, &rdev->flags) &&
!test_bit(Blocked, &rdev->flags))
spares++;
if (rdev->raid_disk < 0