powerpc/85xx: issue 15 EOI after core reset for FSL CoreNet devices
This is listed as a requirement for Freescale CoreNet based devices (e.g
p4080ds with MPIC v4.x) after issuing a core reset to properly clear pending
interrupts.
Signed-off-by: Matthew McClintock <msm@freescale.com>
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
diff --git a/arch/powerpc/sysdev/mpic.c b/arch/powerpc/sysdev/mpic.c
index 9678081..0842c6f 100644
--- a/arch/powerpc/sysdev/mpic.c
+++ b/arch/powerpc/sysdev/mpic.c
@@ -1748,6 +1748,7 @@
struct mpic *mpic = mpic_primary;
u32 pir;
int cpuid = get_hard_smp_processor_id(cpu);
+ int i;
/* Set target bit for core reset */
pir = mpic_read(mpic->gregs, MPIC_INFO(GREG_PROCESSOR_INIT));
@@ -1759,6 +1760,15 @@
pir &= ~(1 << cpuid);
mpic_write(mpic->gregs, MPIC_INFO(GREG_PROCESSOR_INIT), pir);
mpic_read(mpic->gregs, MPIC_INFO(GREG_PROCESSOR_INIT));
+
+ /* Perform 15 EOI on each reset core to clear pending interrupts.
+ * This is required for FSL CoreNet based devices */
+ if (mpic->flags & MPIC_FSL) {
+ for (i = 0; i < 15; i++) {
+ _mpic_write(mpic->reg_type, &mpic->cpuregs[cpuid],
+ MPIC_CPU_EOI, 0);
+ }
+ }
}
#endif /* CONFIG_SMP */