tree 6c3b5280f04776528bb7183aa1f2a3afe71534ca
parent 7a36a752d006f6874049da510297eeb7f09d92a7
author Michael Hamel <mhamel@adi.co.nz> 1215190770 -0700
committer Linus Torvalds <torvalds@linux-foundation.org> 1215193205 -0700

rtc-x1205: Fix alarm set

I have discovered that the current version of rtc-x1205.c does not work
correctly when asked to set the alarm time by the RTC_WKALM_SET ioctl()
call.  This happens because the alarm registers do not behave like the
current-time registers.  They are non-volatile.  Two things go wrong:

- the X1205 requires a 10 msec delay after any attempt to write to the
  non-volatile registers.  The x1205_set_datetime() routine does the write
  as 8 single-byte writes without any delay.  Only the first write
  succeeds.  The second is NAKed because the chip is busy.

- the X1205 resets the RWEL bit after any write to the non-volatile
  registers.  This would lock out any further writes after the first even
  with a 10msec delay.

I fix this by doing a single 8-byte write and then waiting 10msec for the
chip to be ready.  A side effect of this change is that it will speed up
x1205_rtc_set_time() which uses the same code.

I have also implemented the 'enable' bit in the rtc_wkalm structure, which
the existing driver does not attempt to do.  I have modified both
x1205_rtc_set_alarm() to set the AL0E bit, and x1205_rtc_read_alarm() to
return it.

I have tested this patch on a LinkSys NSLU2 under OpenWRT, but on no other
hardware.  On the NSLU2 the X1205 correctly asserts its IRQ pin when the
alarm time matches the current time.

[akpm@linux-foundation.org: clean up over-parenthesisation]
Signed-off-by: Michael Hamel <mhamel@adi.co.nz>
Signed-off-by: Alessandro Zummo <a.zummo@towertech.it>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>