| /* $Date: 2005/11/23 16:28:53 $ $RCSfile: vsc8244_reg.h,v $ $Revision: 1.1 $ */ |
| #ifndef CHELSIO_MV8E1XXX_H |
| #define CHELSIO_MV8E1XXX_H |
| |
| #ifndef BMCR_SPEED1000 |
| # define BMCR_SPEED1000 0x40 |
| #endif |
| |
| #ifndef ADVERTISE_PAUSE |
| # define ADVERTISE_PAUSE 0x400 |
| #endif |
| #ifndef ADVERTISE_PAUSE_ASYM |
| # define ADVERTISE_PAUSE_ASYM 0x800 |
| #endif |
| |
| /* Gigabit MII registers */ |
| #define MII_GBMR 1 /* 1000Base-T mode register */ |
| #define MII_GBCR 9 /* 1000Base-T control register */ |
| #define MII_GBSR 10 /* 1000Base-T status register */ |
| |
| /* 1000Base-T control register fields */ |
| #define GBCR_ADV_1000HALF 0x100 |
| #define GBCR_ADV_1000FULL 0x200 |
| #define GBCR_PREFER_MASTER 0x400 |
| #define GBCR_MANUAL_AS_MASTER 0x800 |
| #define GBCR_MANUAL_CONFIG_ENABLE 0x1000 |
| |
| /* 1000Base-T status register fields */ |
| #define GBSR_LP_1000HALF 0x400 |
| #define GBSR_LP_1000FULL 0x800 |
| #define GBSR_REMOTE_OK 0x1000 |
| #define GBSR_LOCAL_OK 0x2000 |
| #define GBSR_LOCAL_MASTER 0x4000 |
| #define GBSR_MASTER_FAULT 0x8000 |
| |
| /* Vitesse PHY interrupt status bits. */ |
| #if 0 |
| #define VSC8244_INTR_JABBER 0x0001 |
| #define VSC8244_INTR_POLARITY_CHNG 0x0002 |
| #define VSC8244_INTR_ENG_DETECT_CHNG 0x0010 |
| #define VSC8244_INTR_DOWNSHIFT 0x0020 |
| #define VSC8244_INTR_MDI_XOVER_CHNG 0x0040 |
| #define VSC8244_INTR_FIFO_OVER_UNDER 0x0080 |
| #define VSC8244_INTR_FALSE_CARRIER 0x0100 |
| #define VSC8244_INTR_SYMBOL_ERROR 0x0200 |
| #define VSC8244_INTR_LINK_CHNG 0x0400 |
| #define VSC8244_INTR_AUTONEG_DONE 0x0800 |
| #define VSC8244_INTR_PAGE_RECV 0x1000 |
| #define VSC8244_INTR_DUPLEX_CHNG 0x2000 |
| #define VSC8244_INTR_SPEED_CHNG 0x4000 |
| #define VSC8244_INTR_AUTONEG_ERR 0x8000 |
| #else |
| //#define VSC8244_INTR_JABBER 0x0001 |
| //#define VSC8244_INTR_POLARITY_CHNG 0x0002 |
| //#define VSC8244_INTR_BIT2 0x0004 |
| //#define VSC8244_INTR_BIT3 0x0008 |
| #define VSC8244_INTR_RX_ERR 0x0001 |
| #define VSC8244_INTR_MASTER_SLAVE 0x0002 |
| #define VSC8244_INTR_CABLE_IMPAIRED 0x0004 |
| #define VSC8244_INTR_FALSE_CARRIER 0x0008 |
| //#define VSC8244_INTR_ENG_DETECT_CHNG 0x0010 |
| //#define VSC8244_INTR_DOWNSHIFT 0x0020 |
| //#define VSC8244_INTR_MDI_XOVER_CHNG 0x0040 |
| //#define VSC8244_INTR_FIFO_OVER_UNDER 0x0080 |
| #define VSC8244_INTR_BIT4 0x0010 |
| #define VSC8244_INTR_FIFO_RX 0x0020 |
| #define VSC8244_INTR_FIFO_OVER_UNDER 0x0040 |
| #define VSC8244_INTR_LOCK_LOST 0x0080 |
| //#define VSC8244_INTR_FALSE_CARRIER 0x0100 |
| //#define VSC8244_INTR_SYMBOL_ERROR 0x0200 |
| //#define VSC8244_INTR_LINK_CHNG 0x0400 |
| //#define VSC8244_INTR_AUTONEG_DONE 0x0800 |
| #define VSC8244_INTR_SYMBOL_ERROR 0x0100 |
| #define VSC8244_INTR_ENG_DETECT_CHNG 0x0200 |
| #define VSC8244_INTR_AUTONEG_DONE 0x0400 |
| #define VSC8244_INTR_AUTONEG_ERR 0x0800 |
| //#define VSC8244_INTR_PAGE_RECV 0x1000 |
| //#define VSC8244_INTR_DUPLEX_CHNG 0x2000 |
| //#define VSC8244_INTR_SPEED_CHNG 0x4000 |
| //#define VSC8244_INTR_AUTONEG_ERR 0x8000 |
| #define VSC8244_INTR_DUPLEX_CHNG 0x1000 |
| #define VSC8244_INTR_LINK_CHNG 0x2000 |
| #define VSC8244_INTR_SPEED_CHNG 0x4000 |
| #define VSC8244_INTR_STATUS 0x8000 |
| #endif |
| |
| |
| /* Vitesse PHY specific registers. */ |
| #define VSC8244_SPECIFIC_CNTRL_REGISTER 16 |
| #define VSC8244_SPECIFIC_STATUS_REGISTER 0x1c |
| #define VSC8244_INTERRUPT_ENABLE_REGISTER 0x19 |
| #define VSC8244_INTERRUPT_STATUS_REGISTER 0x1a |
| #define VSC8244_EXT_PHY_SPECIFIC_CNTRL_REGISTER 20 |
| #define VSC8244_RECV_ERR_CNTR_REGISTER 21 |
| #define VSC8244_RES_REGISTER 22 |
| #define VSC8244_GLOBAL_STATUS_REGISTER 23 |
| #define VSC8244_LED_CONTROL_REGISTER 24 |
| #define VSC8244_MANUAL_LED_OVERRIDE_REGISTER 25 |
| #define VSC8244_EXT_PHY_SPECIFIC_CNTRL_2_REGISTER 26 |
| #define VSC8244_EXT_PHY_SPECIFIC_STATUS_REGISTER 27 |
| #define VSC8244_VIRTUAL_CABLE_TESTER_REGISTER 28 |
| #define VSC8244_EXTENDED_ADDR_REGISTER 29 |
| #define VSC8244_EXTENDED_REGISTER 30 |
| |
| /* PHY specific control register fields */ |
| #define S_PSCR_MDI_XOVER_MODE 5 |
| #define M_PSCR_MDI_XOVER_MODE 0x3 |
| #define V_PSCR_MDI_XOVER_MODE(x) ((x) << S_PSCR_MDI_XOVER_MODE) |
| #define G_PSCR_MDI_XOVER_MODE(x) (((x) >> S_PSCR_MDI_XOVER_MODE) & M_PSCR_MDI_XOVER_MODE) |
| |
| /* Extended PHY specific control register fields */ |
| #define S_DOWNSHIFT_ENABLE 8 |
| #define V_DOWNSHIFT_ENABLE (1 << S_DOWNSHIFT_ENABLE) |
| |
| #define S_DOWNSHIFT_CNT 9 |
| #define M_DOWNSHIFT_CNT 0x7 |
| #define V_DOWNSHIFT_CNT(x) ((x) << S_DOWNSHIFT_CNT) |
| #define G_DOWNSHIFT_CNT(x) (((x) >> S_DOWNSHIFT_CNT) & M_DOWNSHIFT_CNT) |
| |
| /* PHY specific status register fields */ |
| #define S_PSSR_JABBER 0 |
| #define V_PSSR_JABBER (1 << S_PSSR_JABBER) |
| |
| #define S_PSSR_POLARITY 1 |
| #define V_PSSR_POLARITY (1 << S_PSSR_POLARITY) |
| |
| #define S_PSSR_RX_PAUSE 2 |
| #define V_PSSR_RX_PAUSE (1 << S_PSSR_RX_PAUSE) |
| |
| #define S_PSSR_TX_PAUSE 3 |
| #define V_PSSR_TX_PAUSE (1 << S_PSSR_TX_PAUSE) |
| |
| #define S_PSSR_ENERGY_DETECT 4 |
| #define V_PSSR_ENERGY_DETECT (1 << S_PSSR_ENERGY_DETECT) |
| |
| #define S_PSSR_DOWNSHIFT_STATUS 5 |
| #define V_PSSR_DOWNSHIFT_STATUS (1 << S_PSSR_DOWNSHIFT_STATUS) |
| |
| #define S_PSSR_MDI 6 |
| #define V_PSSR_MDI (1 << S_PSSR_MDI) |
| |
| #define S_PSSR_CABLE_LEN 7 |
| #define M_PSSR_CABLE_LEN 0x7 |
| #define V_PSSR_CABLE_LEN(x) ((x) << S_PSSR_CABLE_LEN) |
| #define G_PSSR_CABLE_LEN(x) (((x) >> S_PSSR_CABLE_LEN) & M_PSSR_CABLE_LEN) |
| |
| //#define S_PSSR_LINK 10 |
| //#define S_PSSR_LINK 13 |
| #define S_PSSR_LINK 2 |
| #define V_PSSR_LINK (1 << S_PSSR_LINK) |
| |
| //#define S_PSSR_STATUS_RESOLVED 11 |
| //#define S_PSSR_STATUS_RESOLVED 10 |
| #define S_PSSR_STATUS_RESOLVED 15 |
| #define V_PSSR_STATUS_RESOLVED (1 << S_PSSR_STATUS_RESOLVED) |
| |
| #define S_PSSR_PAGE_RECEIVED 12 |
| #define V_PSSR_PAGE_RECEIVED (1 << S_PSSR_PAGE_RECEIVED) |
| |
| //#define S_PSSR_DUPLEX 13 |
| //#define S_PSSR_DUPLEX 12 |
| #define S_PSSR_DUPLEX 5 |
| #define V_PSSR_DUPLEX (1 << S_PSSR_DUPLEX) |
| |
| //#define S_PSSR_SPEED 14 |
| //#define S_PSSR_SPEED 14 |
| #define S_PSSR_SPEED 3 |
| #define M_PSSR_SPEED 0x3 |
| #define V_PSSR_SPEED(x) ((x) << S_PSSR_SPEED) |
| #define G_PSSR_SPEED(x) (((x) >> S_PSSR_SPEED) & M_PSSR_SPEED) |
| |
| #endif |